3
NOTE: This owner’s manual covers various models of lawnmowers. The units illustrated may vary slightly
from your unit. Follow only those instructions which pertain to your model lawnmower.
1.
Remove loose parts and any packing material which
may be between upper and lower handles.
a. Pullhandleup fromand backpositionon theA. SeeupperFigurehandle1. to raise the
Setup and
b. Tighten hand knobs (star knobs) securing upper
handle to lower handle. Make sure that each
carriage bolt is seated properly in the handle.
Adjustments
!
NOTE: On some models wing nuts have been replaced
with star knobs. Figures show wing nuts only.
Locateside of lowerhairpinhandle.clip in one hole on the weld pin on each
2.
a. Remove hairpin clip from this hole. Using a pair of
pliers, insert hairpin clip into the other hole on the
weld pin. Repeat on other side.
"
WARNING
b. Place one carriage bolt (found in the hardware
pack included with your unit) in the upper hole of
the right handle mounting bracket from the inside
outward. See Figure 2. Secure with one wing nut
(star knobs). Repeat process on the left side.
Disconnect and
Figure 1
ground the spark
plug wire as instruct-
ed in the separate
engine manual.
3.
The rope guide (pigs tail) is part of the grass catcher
support rod attached to the lower handle. See Figure 3.
a. Holdhandle.thePositionblade controlA. handle against the upper
"
b. Pull the starter rope out of the engine slowly until it
extends past the rope guide (pigs tail). Position B.
c. Guide the starter rope around the rope guide
(pig tail) until the rope is securely in the center.
Position C.
d. Tighten rope guide wing nut (star knob).
4.
Insert post on cable ties into holes provided on the
lower handle. Pull cable tie tight and trim excess. See
Figure 4.
!
Your mower is shipped
with the handle in the
higher height position.
NOTE: Each end of
the lower handle must
be placed in the same
relative position.
NOTE: Your unit is shipped as a mulcher with the
Figure 2
mulching plug installed.
!
7ING�.UTS
IMPORTANT
This unit is shipped
WITHOUT GASOLINE
or OIL. After assembly,
service engine with
gasoline and oil as
"
instructed in the separate
engine manual packed
with your unit.
-ULCHING
0LUG
#
Figure 3
Figure 4
6
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, White Outdoor Lawn Mower Manuals |
|---|---|
| Tags | MTD 900, White Outdoor 900 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)