Discharge Chute
Ignition Key
The angle of the discharge chute controls the distance
that the snow is thrown. Tilt the discharge chute up for
greater distance; tilt down for less distance. Loosen the
hand knob on the side of the discharge chute to adjust.
Tilt the chute to the desired position, and tighten the
knob.
Used to start engine. Put key in “ON” position to start
for both electric and recoil start engines. Follow starting
instructions given in the next section.
Recoil Starter
Used to manually start the engine.
Electric Starter
Used to start engine with a 120V power source
Choke Lever
Place choke lever in “ON” position to start a cold
engine. This lever is located near the throttle housing
on the engine. See Figure 5 inset.
Plug for Electric Start
Requires use of a three-prong outdoor extension cord
Primer Button
and a 120V power source
Spark Plug Access
Spark plug located under the access cover.
Used to inject fuel directly into the carburetor to insure
fast starts in cold weather. Follow engine manual to
prime engine.
SECTION 4: OPERATING YOUR SNOW THROWER
Before Starting
Press auger
control handle
to engage
auger
WARNING: Read, understand, and follow all
instructions and warnings on the machine and
in this manual before operating.
Turn handle
•
The spark plug wire was disconnected for safety.
Attach spark plug wire to spark plug before starting.
to change
discharge
direction
Recoil
Starter
Gas and Oil Fill-Up
Primer
Key
•
Check oil and gasoline level and add if necessary.
Follow related instructions in the seperate engine
manual packed with your snow thrower.
Electric
Starter
Choke
WARNING: Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never
fuel the machine indoors or while the engine is
hot or running. Extinguish cigarettes, cigars,
pipes and other sources of ignition.
Lever
Spark Plug Access
Figure 6
To Start Engine
•
•
•
•
The electric starter is equipped with a grounded
three-wire power cord and plug, and is designed to
operate on 120 volt AC household current.
Determine that your house wiring is a three-wire
grounded system. Ask a licensed electrician if you
are not certain.
If your home wiring system is not a three-wire
grounded system, do not use this electric starter
under any conditions.
If your home electrical system is grounded, but
a three-hole receptacle is not available, one should
be installed by a licensed electrician before using
the electric starter.
•
•
Insert ignition key into slot. Turn key to ON position.
Now follow the instructions below as it pertains to
your unit.
Electric Starter
WARNING: The electric starter must be
used with a properly grounded three-prong
receptacle at all times to avoid the possibility of
electric shock. Follow all instructions carefully
prior to operating the electric starter.
7
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD Snow Blower Manual, White Outdoor Snow Boss 721 Snow Blower Thrower Owners Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Lawn and Garden readers have rated MTD White Outdoor Snow Boss 721 Snow Blower Owners Manual 5.0 out of 5.0 based on 1 product reviews. great explaination, clear detailed instructions.