MTD White Outdoor Snow SB1350W Snow Blower Owners Manual

Engine
Pulley
Brake
Bracket
Assembly
Auger Control
Belt
Large
Shoulder
Bolt
Pulley
Extension
Spring
Figure 18  
Auger
Idler
Rod
Belt
Keepers
Hex Screw
Belleville Washer
Figure 21  
Ferrule
Proper Adjustment   With the auger clutch lever in
the disengaged position the top surface of the new
belt should be even with the outside diameter of the
pulley. To adjust, disconnect ferrule from the brake
bracket  assembly   and  thread  ferrule   in  (towards
idler)  to  increase  tension  on  belt,  out  to  decrease
tension.
Brake
Bracket
Assembly
Cable
Roller
Guide
Z
Fitting
NOTE: The   brake  puck   must  always   be   firmly
seated  in  the  pulley  groove  when  the  auger  clutch
lever is in the disengaged position.
Figure 19  
Auger
Housing
Drive Belt
Remove
Screw
Lock Washer
1.
Unhook  extension  spring   from  the  belt  cover
plate. See Figure 18.
Frame Assembly
2.
Remove  drive  belt  from  the  engine  pulley  and
bottom drive pulley.
3.
4.
Replace belt and reassemble in reverse order.
Reassemble the two halves of the unit hooking
the lower portion of the auger housing over the
stationary shoulder bolts in the frame assembly.
Figure 20  
5.
6.
Secure the two halves with the two screws and
lock washers
8.
9.
Separate  the   auger  housing   from  the   frame
assembly  by   tilting  the   housing  forward   and
pulling up the handles.  
Attach the Z”  fitting of the cable into the brake
bracket assembly. See Figure 19.
Using a 1/2 wrench remove the hex screw and
belleville washer from the centre of the pulley on
the   auger   housing.    Lift   the   brake   bracket
assembly  out  of  the  pulley  groove  and  remove
the pulley. See Figure 21. Be careful not to lose
the key.
7.
8.
Slip the auger control belt over engine pulley.
Insert  ferrule  on   auger  idler  rod   into  bracket
assembly and secure with flat washer and cotter
pin.
9.   Reassemble   the  large  shoulder  bolt  and  lock
washer as shown in Figure 18.
10.
11.
Remove  and  replace  auger  control  belt  inside
belt keepers.
10. Reassemble   belt  cover   and  chute  directional
control.
Reassemble  pulley  to  auger  housing  with  hex
screw  and  belleville  washer  (cupped  is  toward
the  pulley).  Be  certain  key  is  in  place  on  shaft
and brake puck is seated in the pulley groove.
11. Remove plastic film from gas cap.
12
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website