“Z” End
Jam Nut
Shave Plate
Carriage Bolts
High
Low
Skid
Shoes
Auger Control
Cable
Hex Nuts
Figure 7
Figure 8
•
Recheck adjustment; readjust as necessary and
tighten the jam nut.
NOTE: Make certain the entire bottom surface of skid
shoe is against the ground to avoid uneven wear on the
skid shoes.
Skid Shoe
The space between the shave plate and the ground can
be adjusted by repositioning the skid shoes. For close
snow removal, place skid shoes in the low position. Use
middle or high position when area to be cleared is
uneven. See Figure 8. When operating on gravel,
always put skid shoes in the high position.
Tire Pressure (Pneumatic Tires)
The tires are overinflated for shipping purposes.
•
Check tire pressure. Maintain pressure between 15
to 20 psi. Refer to tire sidewalls for recommended
tire pressure.
NOTE: If the tire pressure is not equal in both tires, the
unit may pull to one side or the other.
Adjust skid shoes as follows:
•
Loosen, but do not remove, the two hex nuts which
fasten the skid shoe to the auger housing.
Raise or lower the skid shoe to desired position.
Retighten the hex nuts loosened earlier.
WARNING: Maximum tire pressure under
any circumstance is 30 psi. Equal tire pressure
should be maintained at all times. Excessive
pressure (over 30 psi) when seating beads
may cause tire/rim assembly to burst with
force sufficient to cause serious injury.
•
•
•
Repeat on the other side of the snow thrower.
7
Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
---|---|
Tags | MTD 31AH553G401, MTD Snow Blower Manual, Yard Man 31AH553G401 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | Yard-Man, 31AH553G401, Snow Blower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)