OPERATION
CHECK THE OIL (BEFORE STARTING ENGINE)
TEMPERATURE
(-18°C) and above
(-18°C) and below
TYPE OF OIL
S.A.E. 5W30
Synthetic 5W30
0°F
0°F
NOTE: The engine was shipped from the factory filled with oil.
Check the level of the oil. Add oil as needed.
1.
Make sure the unit is level. Use a high quality detergent oil classified
“For Service SG, SH, SJ, SL, or higher”.
SAE VISCOSITY GRADES
2.
3.
4.
Remove the oil fill cap/dipstick (A, Figure 9) and wipe with a clean cloth.
Insert the oil fill cap/dipstick and turn clockwise to tighten.
Remove the oil fill cap/dipstick and check the oil.
5W30
NOTE: Do not check the level of the oil while the engine runs.
Synthetic 5W30
5.
If necessary, add oil until the oil reaches the FULL mark on the oil fill
cap/dipstick. Do not add too much oil.
F
−20 0 20 32 40
6.
Tighten the oil fill cap/dipstick securely each time you check the oil
level.
C
−30
−20
−10 0 10
NOTE: For extreme cold operating conditions of 0°F (-18°C) and
below, use a synthetic 5W30 motor oil for easier starting.
NOTE: S.A.E. 5W30 motor oil may be used to make starting
easier in areas where the temperature is 20°F (-7°C) to 0°F
FULL
(-18°C).
Synthetic 5W30 is acceptable for all temperatures.
A
DO NOT mix oil with gasoline. See Chart for oil
recommendations.
Checking the Oil
Figure 9
15
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 1695720 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)