SNOWTHROWER REMOVAL
USING SNOWTHROWER
Refer to figures 6-10 on pages 8-10 for removal proce-
dures.
A CAUTION
with engine running slowly to
I
1.
2.
3.
4.
Park tractor on hard level surface.
Start
prevent damage to snowthrower and tractor.
Lower snowthrower attachment to ground.
Stop engine, lock parking brake, and remove key.
1.
Run engine at one quarter throttle.
2. Engage PTO switch to start snowthrower.
3. Run engine at full throttle.
Pull coupler (A, figure 9) on snowthrower PTO shaft
and disconnect from tractor’s PTO shaft.
5.
6.
Remove PTO support rod (C, figure 6) from retaining
hook (D) and support PTO driveshaft (A).
4.
Lower snowthrower to ground and slowly drive into
area to be cleared.
See figure 10. Remove large ring pin C) securing
bottom half of handcrank from spiral spring shaft (B)
and remove handcrank.
A CAUTION
7.
Remove small ring pin holding upper half of
handcrank in bracket and remove handcrank.
When operating snowthrower, do not use down-
ward pressure, in order to avoid damage to cutting
and snowthrower.
Note: Chute Rotator Bracket (refer to figure 2, page 6)
can be left installed or removed for operation of other
attachments.
8.
Pull out shot pins (A, figure 7) on rear of snowthrower
and turn until roll pin fits in groove. Repeat for other
s i d e .
5.
Disengage PTO switch to stop snowthrower.
9.
Start tractor, lower hitch, and slowly
snowthrower.
from
A WARNING
If any object is picked up and/or thrown, other than
snow, stop snowthrower and tractor (stop engine,
lock parking brake and remove key) immediately
and inspect for damage.
Note: Leave PTO
by PTO support rod.
on
IO. Store snowthrower with PTO, handcrank and chute
rotator bracket (if removed).
HITCH REMOVAL
Refer to figure 3, page 7 and figure 5, page 8 for hitch
removal
procedures.
1.
2.
3.
Park tractor on hard level surface.
Stop engine, lock parking brake, and remove key.
Remove spring clip and clevis pin (E, figure 5) secur-
ing lift rod front clevis to hitch lift arm.
4.
5.
See figure 3. Remove spring clip (E) and clevis pin
(D), securing lift rod rear clevis (B) to tractor lift lever
(F). Remove lift rod (A).
See figure 5. Remove left and right spring clips (D)
and clevis pins (C) securing attaching links to tractor
hitch.
6.
7.
See figure 5. Raise hitch and pull foward to remove
hitch pins (A) from tractor hitch brackets(B).
Remove and store hitch with lift arm and attaching
hardware.
1
2
| Categories | Simplicity Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Simplicity 1692243, Simplicity 1692244 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Simplicity, Snow Blower |
| Document File Type | |
| Publisher | simplicitymfg.com |
| Wikipedia's Page | Simplicity Outdoor |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)