Troubleshooting, Adjustments, & Service
WARNING
Before beginning any repair stop the engine,
remove the key, disconnect the spark plug wire,
and wait for all moving parts to stop.
AUGER CONTROL ADJUSTMENT
Inspection
B
1.
Inspect the auger cable for kinks, wear, or frayed
cable strands. Replace if worn or damaged.
A
2.
3.
4.
Start the engine.
Engage the auger control for 5 seconds.
Disengage the auger control. The auger should stop
Figure 5. Auger Cable Adjustment - Disengaged
A. Cable Spring
in 5 seconds or less. If not, perform the auger control B. Jam Nut
adjustment.
Adjustment
1.
2.
Turn the engine OFF.
With the auger control disengaged, measure the
length of the cable spring (A, Figure 5).
3.
4.
Engage the auger control and measure the length of
the expanded cable spring (A, Figure 6).
The cable spring should be stretched 1/2”-3/4”
(1.3cm-1.9cm)
when the auger control is engaged. If
not, proceed to step 4.
Loosen the jam nut (B, Figure 5) at the upper end of
the cable. Hold the threaded end of the cable and
turn the cable clockwise until the desired extension is
achieved. Retighten the jam nut and repeat steps 2-
3.
A
Figure 6. Auger Cable Adjustment - Engaged
A. Cable Spring
If the cable sheath cannot be adjusted to achieve
1/2”-3/4”
(1.3cm-1.9cm) of spring deflection, the
auger belt idler pulley can be adjusted. See the fol-
lowing section.
WARNING
DO NOT over-tighten the cable. The control cable
must have some slack when in the disengaged
position for the auger brake to function properly.
If the auger does not stop within 5 seconds of the
auger control being released, see your dealer.
14
Categories | Simplicity Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Simplicity 1694382, Simplicity 1694383, Simplicity 319E, Simplicity 319M |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | Simplicity, Snow Blower |
Document File Type | |
Publisher | simplicitymfg.com |
Wikipedia's Page | Simplicity Outdoor |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)