Simplicity 520M 520E 1694585 7085663 1694586 7085664 Snow Blower Owners Manual

Troubleshooting & Service
Lift Cover
from Rear
of unit
Locknuts
Spring
Align rear
Insert front
tabs first when
reinstalling
cover.
tabs & side of
cover when
reinstalling.
Figure 13.  Cover Removal & Installation
Figure 14.  Auger Control Cable
AUGER CONTROL
CABLE ADJUSTMENT
Adjusting the Cable
1.
2.
Remove the engine cover.
The length of the auger control cable is adjustable.
However, it will seldom be necessary to change the
cable length since the operating tension on the drive belt
is maintained by the spring on the end of the cable.
Locate and loosen the lower locknut securing the
auger control cable (shown in Figure 14).
3.
To change the slack in the cable, turn the upper lock-
nut slightly just until the slack between the spring
and the exposed cable has been eliminated.
If the auger turns too slowly under heavy load or
momentary squealing of drive belt is heard when enter-
ing heavy snow, pressure applied to drive belt by idler
pulley must be increased by reducing the slack in the
cable.
4.
Tighten the lower locknut.
5.  Test the units to make certain that the cable has
been adjusted properly.
If the auger continues to turn when the auger control
is released, the cable is too tight. The pressure applied
to the drive belt must be eliminated by increasing the
amount of slack to the cable adjustment.
WARNING
Use extreme care when making adjustments that
require engine to be running. Keep hands,  feet,
hair and loose fitting clothing away from  moving
parts.
WARNING
Make certain the cable is not placing  and tension
on the spring. If the cable places  tension on the
spring, the auger may turn when the  control has
not been engaged.
Testing the Auger Control Cable
Start the snowthrower engine and pull back on auger
control to operate auger. Release auger control and
check to be sure auger stops turning.
Checking the Adjustment.
If auger continues to turn after auger control is
released, cable is too tight and will have to be adjust-
ed to make it longer. Cable must be slightly slack
when auger control is released (away from handle).
1.
Remove the cover. (See page 14.)
2.  Measure the spring while the auger control on the
handle is disengaged. Record this measurement.
3.
4.
Pull the auger control against the handle and again
measure the spring. Record this measurement.
CARBURETOR ADJUSTMENT
The carburetor is properly calibrated and preset at the
factory for efficient cold weather operation. There are no
adjustments.
Compare the two measurements. The measurement
obtained with the spring extended should be 7/16
inch (11 mm) greater than with the spring at rest.
16
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snow Blower Manuals
Tags, , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website