Simplicity 860 1693650 1693651 1693763 1693775 Snow Blower Owners Manual

Troubleshooting, Adjustments, & Service
TROUBLESHOOTING
This section provides troubleshooting and service
instructions. Locate the problem and check the possible
cause/remedy in the order listed.
WARNING
Before   performing    any  adjustment    or  service    to
snowthrower,   stop  the  engine  and  wait  for  moving
parts to  stop. Remove  the key.  To prevent  accidental
starting,  disconnect   the  spark  plug wire  and  fasten
away from the plug.
Also, refer to the engine manufacturers Owners Manual
for additional information.
For problems not covered here, contact your local dealer.
PROBLEM
POSSIBLE CAUSE
REMEDY
Engine fails to start.
1.  Key is OFF.
1.  Push key in to the ON position.
2.  Press Primer Button twice and restart.
3.  Turn valve to OPEN position.
4.  Fill fuel tank.
2.
3.
4.
5.
Failure to Prime cold Engine
Fuel valve is in CLOSED position.
Out of fuel.
Choke OFF - cold engine.
5.  Turn choke to ON, set throttle to
FAST.
6.
7.
Engine flooded.
6.  Turn choke to OFF; try starting.
7.  Check gap. Gap plug, clean elec-
trode, or replace plug as necessary.
8.  Drain tank (Dispose of fuel at an
authorized hazardous waste facility).
Fill with fresh fuel.
Spark plug not sparking.
8.
Water in fuel, or old  fuel.
Engine starts hard or runs poorly.     1.  Fuel mixture too rich.
1.  Move choke to OFF position.
2.  See your dealer for adjustments.
3.  Clean and gap, or replace.
2.
3.
Carburetor adjusted incorrectly.
Spark plug faulty, fouled, or gapped
improperly.
4.
Fuel Cap Vent is blocked.
4.  Clear vent.
Auger does not rotate.
1.  Auger Control not engaged.
1.  Engage Auger Control.
2.
Foreign matter blocking auger.
Auger drive clutch rod slack.
2.  STOP engine and REMOVE the key.
DISCONNECT the spark plug wire.
Clear auger using a narrow board.
See warning in SAFETY RULES.
3.
Tighten to remove slack. See auger
clutch rod adjustment.
3.
4.
Check auger drive belt adjustment.
4.
5.
6.
Auger drive belt slipping.
Broken belt.
5.  Replace belt.
6.  Replace shear pin.
Shear pin broken.
03
14
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 26 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website