Intermediate Frame Snowthrowers
Perform
Safety Checks
E
Check Snowthrower Controls
1.
Check the skid shoes to make sure they are set at the
desired height. Adjust if necessary.
2.
Check the traction drive control (B, Figure 2).
Snowthrower motion should stop when the control is
released.
B
C
3.
4.
Check the auger control (C). Auger movement should
stop when the control is released.
Check the manual chute direction control (D) for prop-
er operation. The discharge chute should rotate freely
in both directions.
5.
6.
Check the deflector for proper operation. The
deflector should pivot freely up and down when the
chute deflector knob (E) is loosened.
D
Check the speed selector (A) for smooth operation.
The control must move freely into each speed posi-
tion gate and remain in position when released.
A
Figure 2. Controls (from operator’s position)
A. Speed Selector
B. Traction Control
C. Auger Engage Control
D. Chute Rotator Control
E. Deflector Control
If controls do not function properly, perform the
appropriate adjustment as shown in the
Adjustment Section.
7.
The auger is secured to the shaft by shear pins,
which will break if the auger strikes an object. Extra
shear pins are provided. Keep these pins in the com-
partment on the belt cover. Lubricate the auger shaft.
Check Operations
1.
With engine at full speed, engage the auger control
and release. Do this ten (10) times. Auger should
come to a complete stop within five seconds each
time. If not, perform Auger Adjustments.
3.
Engage traction control and release. Do this ten
times. Unit should come to a complete stop each
time. If it does not, perform the Traction Drive
Adjustments.
4.
5.
Remove the engine key. The engine must stop.
Move the throttle to STOP. The engine must stop.
09/2007
11
TP 300-4681-01-IW-SN
(0 votes, average: 0 out of 5)