English / USA
Mounting the MultiTool
Removing existing MultiTools
Checking position of gearbox
Adjusting position of gearbox
2
1
3
:
Wear gloves to reduce the risk of
injury from contact with sharp,
pointed MultiTools and/or the hot
surface of the gearbox.
To reduce risk of injury from MultiTool
rotating in the wrong direction, check
that position of gearbox is correct and
adjust if necessary.
:
:
:
Loosen clamp screws on gearbox.
Turn gearbox 180°.
Line up the gearbox in the correct
position.
:
:
Remove the hitch pin and pull the
The gearbox output shaft (1) must be
below the drive tube (2) so that the
MultiTool rotates in the direction of the
arrow (3).
Tighten down the two clamp screws
on the gearbox in the following
sequence:
Tighten first screw moderately.
Tighten second screw moderately.
Tighten down first screw firmly.
Tighten down second screw firmly.
:
MultiTool (if fitted) off the shaft.
Clean the gearbox if necessary.
–
–
–
–
Also refer to chapter on "Mounting the
MultiTool" in the instruction manual of
the other MultiTool.
14
FC-MM
| Categories | Stihl Tiller Cultivator Manuals, Tiller Cultivator Manuals |
|---|---|
| Tags | STIHL FC, STIHL MM |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Tiller Cultivator |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)