English / USA
Motor Management
Adjusting the Carburetor
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
Standard Setting
:
:
:
Shut off the engine.
Mount the cutting tool.
Check the air filter and replace if
necessary.
H
L
1
3
/4
:
:
Turn high speed screw (H)
counterclockwise (max. 3/4 turn) as
far as stop.
Carefully screw the low speed
screw (L) down onto its seat. Then
open it one turn counterclockwise
LA
:
:
Start and warm up the engine.
Adjust idle speed with the idle speed
screw (LA) so that the cutting tool
does not rotate.
Fine Tuning
The carburetor comes from the factory
with a standard setting.
A slight correction of the setting of the
high speed screw (H) may be necessary
if engine power is not satisfactory when
operating at high altitude or at sea level.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
With this carburetor it is only possible to
adjust the engine idle speed within fine
limits.
FS 45, FS 46
27
| Categories | Blower Vacuum and Sweeper Manuals, STIHL Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS 45, STIHL FS 46 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)