English / USA
Adjusting Cutter Bar
0° to 90° Version
Carry out the adjustment only when
the cutting blades are at a standstill
0° to 135° Version
On this version the angle of the cutter
bar can be adjusted in 8 stages between
On this version the angle of the cutter
bar can be adjusted upwards in 4 stages
from 0° (straight) to 45°, and downwards
in 8 stages from 0° to 90° (right angle
facing down). There are therefore 13
possible working positions.
–
engine at idle speed – not in the
starting throttle position.
0°
(straight) and 90° (upwards at right
angle. There are therefore 9 possible
working positions.
There is also a special transport
position.
The gearbox becomes hot during
operation. To reduce the risk of burn
injury, do not touch the gear
housing.
To avoid risk of injury, never touch
the blades while making
adjustments.
:
:
Pull back the sliding sleeve (1) and
use the lever (2) to adjust the joint
by one or several holes.
Release the sliding sleeve and
make sure the pin engages the
quadrant (3).
The sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
20
HL 100
| Categories | Hedge Trimmer Manuals, STIHL Hedge Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL HL 100 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)