English / USA
B
B
Open-face technique
Making sapwood cuts
B = Felling cut
Conventional and open-face technique:
A = felling notch - determines the
direction of the fall
:
:
:
For medium sized or larger trees
make cuts at both sides of the trunk,
at same height as subsequent
felling cut
Cut to no more than width of guide
bar
:
:
:
:
Begin 1 to 2 inches (2,5 to 5 cm)
higher than centre of felling notch
Cut horizontally towards the felling
notch
Leave approx.1/10 of diameter
uncut. This is the hinge
Do not cut through the hinge - you
could lose control of the direction of
the fall
For an open-face cut:
:
Properly place felling notch
perpendicular to the line of fall,
close to the ground
This is especially important in
softwood in summer - it helps
prevent sapwood splintering when
the tree falls.
:
Cut down at app. 50-degree angle
to a depth of app.1/5 to 1/4 of the
trunk diameter
:
:
Make second cut from below at app.
40
degree angle
Drive wedges into the felling cut where
necessary to control the fall.
Remove resulting 90-degree piece
!
Warning!
If the tip of the bar contacts a wedge, it
may cause kickback. Wedges should be
of wood or plastic - never steel, which
can damage the chain.
MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C
19
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MSE 140, STIHL MSE 160, STIHL MSE 180, STIHL MSE 200 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)