Toro 53706 53708 Connecting Valve Wires 18 AWG Direct Burial Sprinkler Irrigation Owners Manual

Connecting the Valve Wires (Figure 3)
Step 1-Route  18 AWG direct-burial sprinkler cable
from the timer to the valves.
Figure 3
Grease Cap
1"
In-line Valve Models  53706 and 53708
Timer Connection
- Installation Guide -
Step 2- Using wire splice connectors, attach either
wire from each valve solenoid to the  white cable
wire. This wire is designated as the  valve
“Common Wire.” Connect the remaining wire
from the solenoid to one of the  color-coded wires.
The Toro 1" in-line electric valves are designed for use
in an automatic sprinkler system controlled by
a 24 V a.c. sprinkler system timer. The valves feature
manual bleed controls which enable the valve to be
operated without the use of the timer. The 53706
valve is designed for slip-fit pipe connections and
model 53708 features female-threaded inlet and
outlet. These valves are generally installed below
grade, grouped with other valves in a manifold
arrangement and housed in a protective valve box.
Common
Wire
Important: All wire splices must  be insulated
with grease caps or similar waterproofing devices.
Step 3-At  the timer, connect the  control wires to
the numbered terminals in the desired operating
sequence and the valve common wire to  the com-
mon terminal.
Figure 4
Open
53706
Important: These valves do not  provide backflow
protection. A backflow prevention device installed between the
1" in-line valve(s) and the water source point of connection is
Step 4-Using  the timer’s manual control  feature,
test the operation of each valve.
53708
Bleed Handle
required in most areas to prevent back-siphoning of contaminants through the sprin-
kler system into the potable water supply. The Toro 1" Pressure Vacuum Breaker
(PVB), model number 53300, is specifically designed for this purpose. Before connect-
ing your irrigation system to the potable water supply, consult with your local water
utility department for information regarding backflow prevention requirements.
Where local water pressure exceeds 70 psi, a pressure regulator should be used. (See
Uniform Plumbing Code, Sec. 1007 [b].) It is advisable to use a regulator with any
automatic valve to assure long life as well as uniform and controllable operation.
Manual Operation (Figure 4)
Bleed Screw (external bleed): To open the valve,
Close
turn the Bleed Screw counterclockwise one full turn
or until water begins discharging from the port.
Note: Removing the bleed screw is not required but
can be removed to help flush debris from the upper
diaphragm area.
Bleed Screw
Valve Specifications:
Operating Pressure: 20–150  PSI
Flow Range: 0.25–30  GPM
Solenoid:
To close the valve, turn the bleed screw clockwise until it stops. Do not over-tighten!
Bleed Handle (internal bleed): To open the valve, move the Bleed Handle counter-
clockwise to the stop. To close the valve, move the handle clockwise until resistance is
felt. Do not over-tighten!
24 V a.c., 60 Hz (nominal)
19
V a.c., 60 Hz (minimum)
Inrush: 0.40 amps, 9.6 VA @ 24  V a.c., 60 Hz
Holding: 0.20 amps, 4.8 VA @ 24  V a.c., 60 Hz
Friction Loss:
The Toro Promise — Limited One-Year Warranty
The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrants, to
the owner, each new piece of equipment against defects in material and workmanship for the period of one year from the date
of purchase.
Neither Toro nor Toro Warranty Company is liable for failure of products not manufactured by them even though such prod-
ucts may be sold or used in conjunction with Toro products.
During such warranty period, we will repair or replace, at our option, any part found to be defective.
Return the defective part to the place of purchase.
Our liability is limited solely to the replacement or repair of defective parts. There are no other express warranties.
This warranty does not apply where equipment is used, or installation is performed, in any manner contrary to Toro’s specifi-
cations and instructions, nor where equipment is altered or modified.
Neither Toro nor Toro Warranty Company is liable for indirect, incidental or consequential damages in connection with
the use of equipment, including but not limited to: vegetation loss, the cost of substitute equipment or services required
during periods of malfunction or resulting non-use, property damage or personal injury resulting from installer’s negligence.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
GPM Flow
0.25
5
10
15
20
30
PSI Loss
2.0
3.5
4.0
3.0
3.3
6.2
Installation Procedure
Note: To ensure ease of installation and optimum valve performance, please read
through the following instructions completely before starting the installation procedure.
Step 1- Route 1" schedule 40 PVC pipe from  the backflow preventer or system
shut-off device to the valve location. Flush  the supply line thoroughly!
Caution: Dirt, rocks and debris entering the  valve can damage the valve and/or
cause the valve to malfunction.
All implied warranties, including those of merchantability and fitness for use, are limited to the duration of this express
warranty.
Some states do not allow limitations of how long an implied warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights and you may have other rights which vary from state to state.
Step 2- The instructions and illustrations on the next  page provide the most com-
monly recommended methods of installing in-line  valves in a manifold arrangement.
Use the appropriate step-by-step instruction for the  valve model being installed.
©
2007 The Toro Company, Irrigation Division
Form Number 373-0163 Rev. B
Product Specification
CategoriesSprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 2 pages
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website