•
•
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 21.
Back out the stop bolt until the support bracket
rests on the auger pulley.
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.
Servicing Friction Wheel Rubber
NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Support
•
•
Drain the gasoline from the snow thrower.
Tip the snow thrower up and forward, so that it rests
on the housing.
Bracket
Frame
•
•
•
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
Remove the click pins which secure the wheels,
and remove the wheels from the axle.
Using a 7/8" wrench to hold the shaft, loosen, but
do not completely remove, the hex bolt and bell
washer on the left end of gear shaft. See Figure 22.
Auger
Pulley
Support
Bracket
Spring
Rear
Auger
Belt
Auger
Housing
Front
Auger Belt
Idler
Spring
Hex Bolt &
Washer
Track
Friction
Wheel
Drive Plate
Stop Bolt
Support Bracket
Auger Pulley
Figure 21
Figure 22
•
•
Lift the auger belt from the auger pulley and slip belt
between the support bracket and the auger pulley.
Repeat this step for the front auger belt.
See Figure 21.
Replace the auger drive belts by following
instructions in reverse order.
•
Lightly tap the hex nut to dislodge the ball bearing
from the right side of frame before removing the hex
nut and bell washer from left end of shaft.
Move the gear shaft to the right and slide the friction
wheel assembly from the shaft. See Figure 23.
Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plates. See Figure 23.
Reassemble new friction wheel rubber to the
friction wheel plates and hub, tightening the six
screws in rotation and with equal force.
Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the shaft
through the assembly. Reassemble in reverse
order.
•
•
Drive Belt
•
•
•
•
Follow the first four steps of the instructions for
servicing the auger belts.
Pull the idler pulley up and lift the belt off the engine
pulley and friction wheel disc. See Figure 20.
Back out the stop bolt until the support bracket
rests on the auger pulley.
Slip the belt between the friction wheel and drive
disc. Remove and replace the belt. Reassemble
following the instructions in reverse order.
•
•
16
Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
---|---|
Tags | MTD E740F, MTD Snow Blower Manual, Yard Machines E740F |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | Yard Machines, E740F, Snow Blower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)