MAINTENANCE AND REPAIR INSTRUCTIONS
Belt Tensioner
SERVICING THE UNIT
Extreme care and knowledge of the system is required when
servicing this unit. Service should be performed by qualified
service personnel only. Replacement parts for this unit must be
identical to the parts they replace. Refer any repair to an
authorized service dealer.
(Idler Arm)
Drive Pulley
INSPECTING/REPLACING THE DRIVE BELT
When servicing the unit, use only original equipment
manufacturer replacement parts. Inspect the drive belt once a
year or every 50 hours of operation, whichever comes first, for
wear. If the drive belt needs to be replaced, use the following
instructions.
WARNING: To avoid serious personal injury,
turn off the unit and allow it to cool. Unplug the
unit before you perform any maintenance.
Belt
Driven
Pulley
1
.
Remove the flange lock nut from the belt case cover with a
wrench or nut driver (Fig. 9).
Washer
2.
Remove the seven (7) screws from the belt case cover
using a #T20 Torx bit or flat blade screwdriver (Fig. 9).
Fig. 10
5.
6.
Reinstall the cover with the seven (7) screws. To make
installation easier, place the narrow part of the cover into
the recess of the housing. Install the top two screws, then
push the rest of the cover down into the recess and over
the rotor shaft. Torque all seven (7) screws to 18-23 in•lb
(2.0-2.5 N•m).
WARNING: To reduce the risk of electrical
shock, replace the cover before connecting the
unit to a power source.
Reinstall the flange lock nut. Torque the nut to
80-100 in•lb (9.0-11.2 N•m).
NOTE: If the flange lock nut is damaged, do not replace it with
a standard nut. Replace only with an original
equipment manufacturer replacement part.
Drive Pulley
Cover
Screws (7)
Belt Tensioner
Belt
Drive Belt
Retainer
Flange Lock Nut
Fig. 9
Driven
Pulley
3.
4.
Pull the belt tensioner (idler arm) away from the drive
pulley. Remove the damaged or broken belt from the
driven pulley and drive pulley inside of the housing.
Discard appropriately (Fig. 10).
Loop the new belt around the drive pulley and driven
pulley (Fig. 10). Pull the belt tensioner (idler arm) away
from the drive pulley to install the belt around the drive
pulley.
Fig. 10a
WARNING: When refitting the belt back into the
main housing, be sure that the belt is to the right of
the Drive Belt Retainer. If the belt is placed to the
left, serious damage may occur.
NOTE: Make sure the washer is still in place on the driven
pulley shaft prior to reinstalling the belt case cover.
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 769-02494, MTD Snow Blower Manual, Yard Man 769-02494 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard-Man, 769-02494, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)