•
Plug the wire from the headlight into the alternator
lead coming from the right side of the engine
underneath the fuel tank.
Cable
Cable
Guide
Alternator Lead
Alternator
Lead
Discharge
Chute
Lamp Wire
Figure 3
NOTE: Wheels are omitted from illustration for clarity.
•
If not already attached, unwrap the headlight wire
which is attached to the headlight, beneath the
handle panel. Wind the headlight wire around the
lower right handle until excess slack is removed.
See Figure 4.
Figure 4
Clean-Out Tool
•
This tool, along with the electric cord, is fastened
with a cable tie to the rear of the auger housing for
shipping purposes. Cut the cable tie and remove
the electric cord before operating the snow thrower.
SECTION 2: KNOW YOUR SNOW THROWER
Drive Control /
Auger Control Lock
Shift Lever
Chute Tilt
Control
Headlight
Chute
Assembly
Auger Drive Control
Electric
Starter
Button
Clean-Out
Tool
Track Steering
Control
Primer
Switch
Box
Chute Directional
Control
Choke
Recoil
Starter
Handle
Safety
Ignition Key
Throttle
Control
Skid Shoe
Auger
Figure 5
WARNING: Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.
Drive Control / Auger Control Lock
The drive control is located on the right handle.
Squeeze the drive control to engage the wheel drive.
Release to stop. See Figure 5.
6
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 730 STE, MTD 730 STE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)