OPERATION
TO USE AUGER PROPEL ACTION
1.
Squeeze the control switch lever down
against the upper handle to allow the au-
ger to turn.
2. To propel forward, raise the handle to al-
low the auger blades to contact the
ground (See Figure 6).
Normal Operating Position
WARNING: The motor is
equipped with a protector that
will disconnect power to the
motor temporarily if the snow thrower is
overworked, and will automatically reset
as the motor cools. If the motor stops,
release the control bar, disconnect the
extension cord and allow the motor to
cool five minutes before continuing op-
eration.
Auger Propelled
Position
Propel
Forward
Figure 6
TO START SNOW THROWER
To start snow thrower operation, proceed as
follows:
IMPORTANT: Use a U.L. listed two conduc-
tor extension cord suitable for outdoor use
in cold weather. Extension cord should be
no longer than 100 feet.
1.
To prevent accidental disconnection of
extension cord from control switch during
operation, loop extension cord through
strain relief clip on control switch (see
Figure 7).
RECOMMENDED EXTENSION CORDS
2. Snap strain relief clip down over loop of
extension cord (see Figure 7). Connect
extension cord to power plug on control
switch.
MINIMUM GAGE FOR CORDS SETS
Volts
120V
Length of Cord in Feet
25ft.
50ft.
100ft.
Ampere
rating
more
Strain Relief
Clip
not
more
than
than
AWG
18
Power Plug
0
6
16
16
16
12
16
14
14
10
Extension Cord
6
10
12
13
18
10
12
16
14
Figure 7
Always connect extension cord to control
switch on snow thrower first, then connect the
other end to a wall receptacle installed in ac-
cordance with local codes and inspection au-
thorities.
3. To operate snow thrower turn key (clock-
wise) and hold in UNLOCKED position
while pulling control switch lever toward
11
F-041020C
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 620000X30N |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)