ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
ASSEMBLY
CONTENTS OF PARTS BAG
1 - Knife to cut carton.
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side of
the snow thrower are from the viewpoint of
the operator’s position behind the unit.
1
1
- Owner’s Manual
- Parts Bag
(Not shown actual size)
TO REMOVE SNOW THROWER
FROM CARTON
1
- Screw
1 - Nut
1 - Plastic Tie
1.
Remove the inserts positioned around
the unit and the packing material.
1
- Key
WARNING: Always wear safety
glasses or eye shields while as-
sembling snow thrower.
2. Cut down all four corners of the carton
and lay the panels flat.
3.
Pull snow thrower out of the carton.
TO ASSEMBLE THE HANDLE
cord and pigtail are not caught be-
tween upper and lower handle.
1.
2.
3.
Remove wrap on upper handle and along
the side of both handles. Discard wrap.
4.
5.
Tighten the tee knobs. Make sure pigtail
is free from the control switch cord.
Loosen the tee knobs on each side of the
upper handle.
Raise the upper handle to the operating
position as shown in the figure above.
Hold upper handle apart to prevent
scratching lower handle.
Secure control switch cord to handle us-
ing plastic tie found in plastic bag. Thread
the pointed end of the tie through the
square end. Pull tie tightly around the
cable and handle, after securing clip ex-
cess from tie.
NOTE: Make sure the control switch
Control Switch
Lever
Chute Control
Rod
Control Switch
Tee Knob
Chute Deflector
Control Switch Cord
Tie
Pigtail
Tee Knob
Figure 1
F-041020C
7
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 620000X30N |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)