MOUNTING THE CONTROLLER
1.
Place the mounting template (provided) on the wall, at or slightly
below eye level. Using a small punch or nail, mark the locations of
the top mounting hole and either the center or two outer lower
mounting hole locations. (Two wood screws are provided with the
controller.)
2.
3.
Unlatch and pull the hinged control module open. Remove two
screws securing the hinged front panel and pull the panel open.
Using a 3/16" (5mm) bit, drill
Figure 4
VALVETEST
through the lower mounting hole
location(s) provided in the cabinet.
See Figure 4.
24VAC
GN
D
SENSOR
EARTHG
ND
Note: For solid masonry wall
installation, drill 1/4" (6.5mm) pilot
holes approximately 1-1/4" (32mm)
deep. Insert the plastic screw
anchors (provided) into the pilot
holes. For hollow wall installation,
use appropriate screw anchoring fasteners.
Lower Mounting
Holes
4.
5.
Install the top mounting screw leaving a 1/4" (6mm) gap between
the screw head and the wall.
Hang the cabinet on the screw using the keyhole slot. Install the
lower screw(s) and tighten securely.
CONNECTING THE VALVE WIRING
Note: A 2" (52mm) conduit opening is provided in the base of
the cabinet for low voltage field wiring. Install conduit at this time
as required.
1.
2.
To provide a field common wire, attach one wire to either solenoid
lead of all sprinkler valves and master valve (optional).
Attach a separate control wire to the remaining solenoid lead of
each valve. Label the control wires with the intended station
number for identification at the controller.
Caution: All wiring splices must be waterproofed to prevent
short circuits and corrosion.
A maximum load of 12 VA (0.5 amps) may be connected to
each station. A maximum load (including master valve) of
30
simultaneously. Exceeding these limits can damage the
controller.
VA (1.25 amps) may be programmed to operate
20
Installation Procedures
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)