To connect the pump start relay:
WARNING: Proper connection of the pump and relay
contacts depends on the pump configuration and may involve
HIGH VOLTAGE. This connection should be per-formed by
a licensed electrical contractor in accordance with all requirements of
the National Electrical Code, applicable state and local codes and the
pump manufacturer ’s recommendations.
1.
Connect one side of the relay
coil to the MV/PUMP terminal.
Figure 6
24 V a.c.
Relay Coil
2.
Connect the other side of the
relay coil to the valve common
/
MV PUMP
Terminal
(
See Figures 5 and 6.
VC/COM terminal.
To Pump
Starter
VC/COM
Terminal
CONNECTING A RAIN SWITCH SENSOR
The Custom Command is designed for use with a normally closed rain
sensor or “Rain Switch.” (Refer to page 6 for additional important rain
switch information and the installation instructions provided with the
rain switch sensor.)
To connect the Toro rain switch sensor:
1.
The Toro Rain Switch cable has
four wires: two copper wires and
two silver wires. Only two of the
wires are used. Connect the
Figure 7
heavier 18 AWG (0.75mm
copper wire and the heavier
AWG (0.75mm ) silver wire
2
)
Jumper Wire
18
2
to the terminals labeled
SENSOR (11). Trim off the
remaining two cable wires.
Normally Closed
Rain Switch Sensor
2.
Remove the jumper wire from
the “SEN SOR” terminals and
connect the sensor wires in
either order. See Figure 7.
22
Installation Procedures
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)