Husqvarna 326P4 X-Series Chainsaw Owners Manual

MAINTENANCE
Final setting of the idling speed T
Adjust the idling speed with
the screwT, if it is necessary
to readjust. First turn  the
idle speed adjusting screwT
clockwise until the cutting-
eqipment starts to rotate/
move.
Correctly adjusted carburetor
A correctly adjusted carburetor means that the machine
accelerates without hesitation and the machine 4-cycles a
little at max speed. Furthermore, the cuttingequipment,
must not rotate/move at  idling. A too lean adjusted low
speed needle L may cause starting difficulties and bad
acceleration.
A too lean adjusted high speed needle H gives lower power
= less capacity, bad acceleration and/or damage to the
engine.
Then turn,  counter-clock-
wise until the cutting-
equipment stops. A correctly
adjusted idle speed setting
occurs when the engine runs
smoothly in every position.
It should also be good
A too rich adjustment of the two speed needles L and H
gives acceleration problems or too low working speed.
margin to the rpm when the
cuttingequipment starts to
rotate/move.
CAUTION! Contact your  servicing dealer, if the idle speed
setting cannot be adjusted so that the  cutting attachment
stops. Do not use the machine until  it has been properly
adjusted or repaired.
High speed needle
H
The high speed needle
affects the machine s power,
speed, temperature and fuel
consumption. A too lean
adjustment on the high
speed needle H (the high
speed needle H is screwed in
too much) gives a too high
speed resulting in engine
damage. Do not allow the
engine to run at full speed
for more than 10 seconds.
Apply full throttle and turn
the high speed needle H
slowly anticlockwise until
the engine runs unevenly.
The high speed needle H is
then turned slowly
clockwise a little until the
engine runs smoothly.
Note the engine should be
run unloaded when
adjusting the high speed
needle.
H
Therefore dismantle the cutting equipment, nut, support
flange and disc drive before adjusting the high speed needle.
The high speed needle is adjusted correctly when the machine
splattersa little .
NOTE! For optimum  setting of the carburetor, contact a
qualified servicing dealer who has a revolution counter at his
disposal.
English
21
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags,
Model Year1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website