SAFETY INSTRUCTIONS
D. Adjusting raker clearance
1.
2.
Undo the bar nut.
•
When correction of the
raker clearance is made
the teeth must be newly
sharpened.
Tension the chain by
turning the chain
tensioning screw
clockwise using the
combination spanner.
Tighten the chain until
it no longer hangs slack
beneath the bar.
We recommend that you
adjust the raker clearance
every third time you
sharpen the chain.
NOTE!This
recommendation assumes
that the length of the
cutting teeth is not
reduced excessively.
3.
Use the combination
spanner to tighten the
blade nut while lifting
the tip of the bar at the
same time. Check that
you can pull the chain
round freely by hand.
•
A FLAT FILE and an
RAKER CLEARANCE
GAUGE are required to
correct the raker
Lubricating cutting equipment
clearance.
!
WARNING!
•
•
Place the gauge over the
raker lip.
Poor lubrication of cutting equipment may
cause the chain to snap and lead to serious,
even fatal injuries.
Place the file over the
part of the lip that
A. Chain oil
protrudes through the
gauge and file off the
excess. The clearance is
correct when you no
longer feel any resistance
as you draw the file over
the gauge.
• Chainsaw chain oil must demonstrate good adhesion to the
chain and also maintain its flow caracteristics regardless of
whether it is warm summer or cold winter weather.
• As a chainsaw manufacturer we have developed an optimal
chain oil which, with its vegetable oil base, is also
biodegradable. We recommend the use of our own oil for
both maximum chain life and to minimise environmental
damage.
Tensioning the saw chain
•
•
•
If our own chain oil is not available, standard chain oil is
recommended.
In areas where oil specifically for lubrication of saw chains is
unavailable, ordinary EP 90 transmission oil may be used.
Never use waste oil!
!
WARNING!
A slack chain may jump off and cause
serious or even fatal injury.
This is dangerous for yourself, the saw and the environment.
•
•
The more you use a
chain the longer it
becomes. It is therefore
important to adjust the
chain regularly to take up
the slack.
B. Filling with chain oil
The oil pump is preset at
the factory to meet most
lubrication requirements
and a full oil tank will last
about half as long as a tank
of fuel. You should
therefore check the level in
the oil tank regularly to
avoid damaging the chain
and bar by running out of
oil.
Check the chain tension
every time you refuel.
NOTE! A new chain has
a running-in period
during which you should
check and adjust the
chain tension more
frequently.
•
As a rule the chain
should be tensioned as
tightly as possible, but
not so tight that you
cannot pull it round
freely by hand.
10
– English
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 325P4, Husqvarna X-Series |
| Model Year | 1995, 1996, 1997, 1998, 1999, 2000, 2001 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)