FUEL HANDLING
Chain oil
Fuelling
•
The chain lubrication
system is automatic. Always
use special chain oil with
good adhesive
Taking the following precautions, will lessen
the risk of fire.
characteristics.
•
Do not smoke or place warm objects in the vicinity of
the fuel.
•
•
In countries where no
special chain oil is available,
EP 90 transmission oil can
be used.
•
•
Always shut off the engine before refuelling.
Slowly open the fuel cap, when filling fuel, so that
possible overpressure is slowly released.
Tighten the fuel cap carefully after fuelling.
Always move the saw from the fuelling area before
starting.
•
•
Never use waste oil. This
results in damage to the oil
pump, the bar and the
chain.
WARNING!
•
•
It is important to use oil of
the right viscosity according
to the air temperature.
The catalytic converter muffler gets very hot
during and after use. This also applies during
idling. Be aware of the fire hazard, especially
when handling the saw near flammable
substances or vapours.
In temperatures below 0 C
o
F) some oils become
too viscous. This can
(32
o
Clean around the fuel cap.
Clean the fuel and chain oil
tanks regularly. The fuel filter
should be changed at least
once a year. Contamination in
the fuel tanks causes
malfunction. Make sure the
fuel is well mixed by shaking
the container before fuelling.
The volume of chain oil and
fuel tanks are adjusted to
each other. Therefore, always
fill chain oil and fuel at the
same time.
overload the oil pump and
result in damage to the oil
pump components.
•
Contact your servicing
dealer when choosing chain
oil.
Min 3 m
(10ft)
English –
27
Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
---|---|
Tags | Husqvarna 355 |
Model Year | 1995, 1996, 1997, 1998, 1999, 2000, 2001 |
Download File |
|
Document Type | Operator's Manual |
Language | English |
Product Brand | Husqvarna, Chainsaw |
Document File Type | |
Publisher | husqvarna.com |
Wikipedia's Page | Husqvarna |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)