Husqvarna 55 Rancher Chainsaw Owners Manual

SAFETY INSTRUCTIONS
Always le cutting teeth from the inside face. Reduce the
To adjust the raker clearance you will need a at le and a
pressure on the return stroke.File all the teeth on one side
rst, then turn the chain saw over and le the teeth on the
other side.
raker gauge.
Place the gauge over the raker lip.
File all the teeth to the same length. When the length of
the cutting teeth is reduced to 4 mm (0.16") the chain is
worn out and should be replaced.
Place the le over the part of the lip that protrudes through
the gauge and le off the excess.The clearance is correct
when you no longer feel any resistance as you draw the
le over the gauge.
General advice on setting raker clearance
When you sharpen the cutting teeth you reduce the raker
clearance (=cutting depth). To maintain optimal cutting
performance you must le back the raker lip to the
recommended height.
Tensioning the chain
See the Technical data section to nd the raker clearance
for your particular chain.
WARNING! A slack chain may jump off and
cause serious or even fatal injury.
!
On a low-kickback cutting link the front edge of the raker
lip is rounded. It is very important that you maintain this
radius or bevel when you adjust the raker clearance.
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take up the
slack.
Check the chain tension every time you refuel. NOTE! A new
chain has a running-in period during which you should check
the tension more frequently.
The position of the chain tensioning screw on our chain saws
varies from model to model. See the What is what? section to
nd out where it is on your model.
We recommend that you use our raker gauge to achieve
the correct clearance and bevel on the raker lip.
Tension the chain as tightly as possible, but not so tight that
you cannot pull it round freely by hand.
WARNING! The risk of kickback is increased
if the raker clearance is too large!
!
Setting the raker clearance
Undo the bar nuts that hold the clutch cover/chain brake.
Use the combination spanner. Then tighten the bar nuts
by hand as tight as you can.
Before setting the raker clearance the cutting teeth should
be newly sharpened. We recommend that you adjust the
raker clearance every third time you sharpen the chain.
NOTE! This recommendation assumes that the length of
the cutting teeth is not reduced excessively.
12
English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags
Model Year2001, 2002, 2003, 2004, 2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 40 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website