Husqvarna 55 Rancher Chainsaw Owners Manual

MAINTENANCE
Correctly adjusted carburettor
Undo the screw in the centre of the pulley and remove the
pulley. Insert and fasten a new starter cord to the pulley.
Wind approx. 3 turns of the starter cord onto the pulley.
Connect the pulley to the recoil spring so that the end of
the spring engages in the pulley. Fit the screw in the
centre of the pulley. Insert the starter cord through the
hole in the starter housing and the starter handle. Make a
secure knot in the end of the starter cord.
When the carburettor is correctly adjusted the machine
accelerates without hesitation and the machine 4-cycles a
little at max speed. It is also important that the chain does not
rotate at idle. If the L-jet is set too lean it may cause starting
difculties and poor acceleration. If the H-jet is set too lean
the machine will have less power, poor acceleration and could
suffer damage to the engine. If the L and H-jets are set too
rich it will lead to acceleration problems or too low a working
speed.
Starter
WARNING! When the recoil spring is wound
up in the starter housing it is under tension
!
and can, if handled carelessly, pop out and
cause personal injury. Always be careful
when changing the recoil spring or the
starter cord. Always wear protective
goggles.
Tensioning the recoil spring
Hook the starter cord in the notch in the pulley and turn
the starter pulley about 2 turns clockwise.
Changing a broken or worn starter cord
CAUTION!  Check that the pulley can be turned at least a
further 1/2 turn when the starter cord is pulled all the way
out.
Loosen the screws that hold the starter against the
crankcase and remove the starter.
Changing a broken recoil spring
Pull out the cord approx. 30 cm and hook it into the notch
in the rim of the pulley. Release the recoil spring by letting
the pulley rotate slowly backwards.
Lift up the starter pulley. See instructions under the
heading Changing a broken or worn starter cord.
Remember that the recoil spring is coiled under tension in
the starter housing.
Remove the recoil spring by tapping the starter, with the
inside facing downwards, gently on a work bench. If the
spring pops out during assembly, coil it up from the
outside, working inwards.
30
English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags
Model Year2001, 2002, 2003, 2004, 2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 40 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website