MAINTENANCE
Replacement of broken recoil and drive
disc springs
Air filter
The air filter must be regularly cleaned to remove dust and
dirt in order to avoid:
Recoil spring (A)
•
•
•
•
•
•
Carburettor malfunctions
Starting problems
•
Lift up the starter pulley. See instructions under the
heading Changing a broken or worn starter cord.
Remember that the recoil spring is coiled under tension
in the starter housing.
Loss of engine power
Unnecessary wear to engine parts
Excessive fuel consumption.
•
•
Remove the cassette with the recoil spring from the
starter.
Remove the air filter after taking off the air filter cover.
When refitting make sure that the air filter seals tightly
against the filter holder. Clean the filter by brushing or
shaking it.
Lubricate the recoil spring with light oil. Fit the cassette
with recoil spring in the starter. Fit the starter pulley and
tension the recoil spring.
Drive disc spring (B)
345e:
•
Undo the bolt in the centre of the pulley and remove the
drive disc and the drive disc spring.
•
Replace the drive disc spring and fit the drive disc above
the spring.
The filter can be cleaned more thoroughly by washing it in
water and detergent.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.
A
A
A HUSQVARNA chain saw can be equipped with different
types of air filters according to working conditions, weather,
season, etc. Contact your dealer for advice.
B
Spark plug
345e
346XP, 353
Fitting the starter
The spark plug condition is influenced by:
•
To fit the starter, first pull out the starter cord and place
the starter in position against the crankcase.Then slowly
release the starter cord so that the pulley engages with
the pawls.
•
•
Incorrect carburetor adjustment.
An incorrect fuel mixture (too much or incorrect type of
oil).
•
Fit and tighten the screws that hold the starter.
•
A dirty air filter.
These factors cause deposits on the spark plug electrodes,
which may result in operating problems and starting
difficulties.
If the machine is low on power, difficult to start or runs poorly
at idle speed: always check the spark plug first before taking
any further action.If the spark plug is dirty, clean it and check
that the electrode gap is 0.020 inch (0.5 mm).The spark plug
36
– English
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 345e, Husqvarna 346XP, Husqvarna 353, Husqvarna TrioBrake |
| Model Year | 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)