MAINTENANCE
use a muffler if the spark arrestor mesh is missing or
•
Undo the screw in the centre of the pulley and remove
defective.
the pulley. Insert and fasten a new starter cord to the
pulley. Wind approx. 3 turns of the starter cord onto
the pulley. Connect the pulley to the recoil spring so
that the end of the spring engages in the pulley.Fit the
screw in the centre of the pulley.Insert the starter cord
through the hole in the starter housing and the starter
handle. Make a secure knot in the end of the starter
cord.
The muffler is designed to reduce the noise level and to
direct the exhaust gases away from the operator. The
exhaust gases are hot and can contain sparks, which may
cause fire if directed against dry and combustible material.
Starter
WARNING! When the recoil spring is
wound up in the starter housing it is under
tension and can, if handled carelessly,
pop out and cause personal injury.
!
Tensioning the recoil spring
•
Hook the starter cord in the notch in the pulley and
turn the starter pulley about 2 turns clockwise.
Care must be exercised when replacing
the return spring or the starter cord.
Wear protective glasses and protective
gloves.
Note! Check that the pulley can be turned at least a
further 1/2 turn when the starter cord is pulled all the
way out.
1
Changing a broken or worn starter cord
•
Loosen the screws that hold the starter against the
crankcase and remove the starter.
2
•
Pull out the cord approx. 30 cm and hook it into the
notch in the rim of the pulley.Release the recoil spring
by letting the pulley rotate slowly backwards.
1
2
32
– English
Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
---|---|
Tags | Husqvarna 576XP |
Model Year | 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 |
Download File |
|
Document Type | Operator's Manual |
Language | English |
Product Brand | Husqvarna, Chainsaw |
Document File Type | |
Publisher | husqvarna.com |
Wikipedia's Page | Husqvarna |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)