ASSEMBLY
Fitting the cutting head (Saw
attachment with shaft)
•
The chain is correctly
tensioned when there is no
slack on the underside of
the bar, but it can still be
turned easily by hand.
Hold up the bar tip and
tighten the bar nuts with
the combination wrench.
•
Fit the cutting head on the
shaft so that the screw (A)
is aligned with the hole in
the shaft as shown.
•
•
Tighten screw A.
Tighten screw B.
B
•
When fitting a new chain,
the chain tension has to be
checked frequently until
the chain is run-in. Check
the chain tension regularly.
A correctly tensioned chain
gives good cutting
NOTE! Make sure that the
drive shaft inside the shaft
engages with the cut-out in
the cutting head.
A
performance and long
lifetime.
Fitting the cutting head (Saw
attachment without shaft)
•
Remove the mitre gear
from the shaft.
Fitting the hanging ring
•
Fit the cutting attachment
to the shaft.
Fit the hanging ring between
the rear handle and the loop
handle. Position the hanging
ring so that the machine is
balanced and comfortable to
work with.
•
•
Tighten screw A.
Tighten screw B.
NOTE! Make sure that
the drive shaft inside the
shaft engages with the cut-
out in the cutting head.
Mounting guide bar and chain
•
Unscrew the bar nut and
remove the guard.
•
Fit the bar over the bar
bolt.Place the bar in its
rearmost position. Place
the chain over the drive
sprocket and in the groove
on the bar. Begin on the
top side of the bar.
Adjusting the harness
You should always use the
harness with the machine to
give maximum control and
reduce strain on your arms
and back.
A
•
•
Make sure that the edges
on the cutting links are
facing forward on the top
side of the bar.
B
1.
2.
Put on the harness.
Hook the machine onto
the hook on the harness.
Fit the clutch cover and
locate the chain adjuster
pin in the hole on the bar.
Check that the drive links
of the chain fit correctly on
the drive sprocket and that
the chain is in the groove
3.
Adjust the length of the
harness so that the hook
is roughly level with your
right hip.
on the bar. Tighten the bar nut finger tight.
•
Tension the chain by using the combination wrench. Turn
the chain adjuster screw clockwise. The chain should be
tensioned until it fits snugly on the underside of the bar.
14
– English
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna S 36, Oregon 90 SG, Oregon 91 VG |
| Model Year | 2002, 2003 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)