Husqvarna 323P4 325P4 325P5 X-Series Chainsaw Owners Manual

SAFETY INSTRUCTIONS
B. Sharpening
cutting tooth
C. General advice on setting raker
clearance
To sharpen cutting teeth you
will need a ROUND FILE
and a FILE GAUGE.
When you sharpen the
cutting teeth you reduce
the RAKER
CLEARANCE (cutting
depth). To maintain
cutting performance
you must file back the
raker teeth to the
1.
2.
Check that the chain is
correctly tensioned. A
slack chain is difficult to
sharpen correctly.
recommended height.
Always file cutting teeth
from the inside face,
reducing the pressure on
the return stroke.
File all the teeth on one
side first, then turn the
machine over and file the
teeth on the other side.
On a low-kickback
cutting link the front
edge of the raker lip is
rounded. It is very
important that you
maintain this radius or
bevel when you adjust
the raker clearance.
3.
File all the teeth to the
same length. When the
length of the cutting teeth
is reduced to 4 mm (.16")
the chain is worn out and
should be replaced.
We recommend the use
of a raker gauge to
achieve the correct
clearance and bevel on
the raker lip.
min 4 mm
(0,16")
!
WARNING!
The risk of kickback is increased if the
raker clearance is too large!
English –
9
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, , ,
Model Year2002, 2003, 2004, 2005, 2006
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website