Poulan 3450 3750 Chainsaw Owners Manual

FUELING & LUBRICATION
STARTING
WARNING: Remove  fuel cap slowly
WARNING:
The  chain   must  not
when refueling.
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
FUELING ENGINE
BURETOR
ADJUSTMENT
within
this
This engine is certified to operate on unleaded
gasoline. Before operation,  gasoline must be
mixed with  a good quality  2-cycle air-cooled
engine oil. We recommend Poulan  or Poulan
ProR brand oil. If you do not use this oil, use a
good quality 2-cycle air-cooled oil designed to
be mixed  at a ratio  of 40:1.   A  40:1 ratio is
obtainedbymixing3.2  oncesof oilwith  1gallon
of unleaded gasoline. Included withthis sawis
a 3.2 ounce  container of Poulan/Weed Eater
brand  oil.   Pour  the  entire contents  of  this
container into 1 gallon  of gasoline to achieve
the proper fuel mixture.
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
To stop  the  engine  move  the ON/STOP
switch to the STOP position.
To start the engine  hold the saw firmly  on
the  ground  as  illustrated.  Make  sure  the
chain is free  to turn without  contacting  any
object.
Use only 15”--18” of rope per pull.
Hold saw firmly while pulling  starter rope.
Starter rope handle
DO NOT USE automotive or boat oil.  These
oils will cause engine damage.  When mixing
fuel  follow  the   instructions  printed  on  the
container. Always  read and follow the  safety
rules  listed   under  HANDLE   FUEL  WITH
CAUTION.
Left hand
on front
handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubrica-
tion. Lubrication is  provided by the automatic
oiler system  when the  oil tank  is kept filled.
Lack of oil will quickly ruin the bar  and chain.
Too little oil  will cause overheating shown  by
smoke coming from the chain and/or discolor-
ation of the bar.
In freezing  weather oil will thicken,  making it
necessary to thin bar and chain oil with a small
amount  (5  to  10%)  of  #1  Diesel   Fuel  or
kerosene.  Bar  and  chain oil  must  be  free
flowingfortheoil  systemto pumpenough  oilfor
adequate lubrication.
Right foot through rear handle
IMPORTANT POINTS TO REMEMBER
Whenpullingthestarterrope,donotuse    thefull
extent of the rope as this can cause the rope to
break. Do not let starter rope snap back. Hold
the handle and let the rope rewind slowly.
For cold  weather  starting,  start the  unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle  trigger.
NOTE
:
Do not cut material with the  choke/
fast idle lever at the FULL CHOKE position.
STARTING  A COLD  ENGINE  (or a
warm  engine  after running  out  of
fuel)
Genuine
PoulanR   bar   and  chain   oil   is
recommended  to  protect  your  unit  against
excessive
wear   from   heat   and   friction.
S  Move ON/STOP switch to the ONposition.
S  Pull the choke/fast idle lever out to the full
extent.
PoulanR oil resists high temperature thinning.
If PoulanR bar and  chain oil is not available,
use a good grade SAE 30 oil.
S  Never use waste oil for bar and chain lubri-
cation.
ON
S  Always stop the engine before removing the
oil cap.
ON/STOP
SWITCH
IMPORTANT
Experience  indicates   that   alcohol--blended
fuels (called gasohol or using ethanol or meth-
anol)can attract moisture which leads to sepa-
ration and  formation of acids  during storage.
Acidic gas can damage the fuel system of an
engine while in storage. To avoid engine prob-
lems,thefuelsystem  shouldbe emptiedbefore
storage for 30 days or  longer.  Drain the gas
tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel
next season. See STORAGE section foraddi-
tional information.
STOP
CHOKE/FAST IDLE LEVER
(SIDE VIEW)
Choke/Fast
Idle Lever
OFF
FULL
S  Press the throttle lock with your right hand.
Squeeze  and   hold  the  throttle   trigger;
Press and hold the fast idle lock with your
forefinger; release  the throttle trigger.
9
Product Specification
CategoriesChainsaw Manuals, Poulan Chainsaw Manuals
Tags,
Model Year2002
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 17 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandPoulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw
Document File TypePDF
Publisherpoulan.com
Wikipedia's PagePoulan
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website