FUELING & LUBRICATION
STARTING
WARNING:
The chain must not
WARNING: Remove fuel cap slowly
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
when refueling.
BURETOR
ADJUSTMENT
within
this
FUELING ENGINE
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
This engine is certified to operate on unleaded
gasoline. Before operation, gasoline must be
mixed with a good quality 2-cycle air-cooled
engine oil. We recommend Poulan PROR
brand oil. If you do not use this oil, use a good
quality 2-cycle air-cooled oil designed to be
mixedataratioof 40:1. A 40:1ratio isobtained
by mixing 3.2 onces of oil with 1 gallon of
unleaded gasoline. Included with this saw is a
To stop the engine move the ON/STOP
switch to the STOP position.
To start the engine hold the sawfirmly on the
ground as illustrated. Make sure the chain is
free to turn without contacting any object.
Use only 15”--18” of rope per pull.
Hold saw firmly while pulling starter rope.
Starter rope handle
3.2
ounce container of Poulan/Weed Eater
brand oil. Pour the entire contents of this
container into 1 gallon of gasoline to achieve
the proper fuel mixture.
Left hand
on front
handle
DO NOT USE automotive or boat oil. These
oils will cause engine damage. When mixing
fuel follow the instructions printed on the
container. Always read and follow the safety
rules listed under HANDLE FUEL WITH
CAUTION.
Right foot through rear handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubrica-
tion. Lubrication is provided by the automatic
oiler system when the oil tank is kept filled.
Lack of oil will quickly ruin the bar and chain.
Too little oil will cause overheating shown by
smoke coming from the chain and/or discolor-
ation of the bar.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a small
amount (5 to 10%) of #1 Diesel Fuel or
kerosene. Bar and chain oil must be free
flowingfortheoil systemto pumpenough oilfor
adequate lubrication.
Genuine Poulan or Poulan PROR bar and
chain oil is recommended to protect your unit
against excessive wear from heat and friction.
Poulan or Poulan PROR oil resists high
temperature thinning. If Poulan or Poulan
PROR bar and chain oil is not available, use a
good grade SAE 30 oil.
IMPORTANT POINTS TO REMEMBER
When pulling the starter rope, do not use the
full extent of the rope as this can cause the
rope to break. Do not let starter rope snap
back. Hold the handle and let the rope rewind
slowly.
For cold weather starting, start the unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
NOTE: Do not cut material with the choke/
fast idle lever at the FULL CHOKE position.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
S Move ON/STOP switch to the ONposition.
S Pull the choke/fast idle lever out to the full
extent.
ON
ON/STOP
SWITCH
S Never use waste oil for bar and chain lubri-
cation.
S Always stop the engine before removing the
STOP
CHOKE/FAST IDLE LEVER
(SIDE VIEW)
oil cap.
IMPORTANT
Experience indicates that alcohol--blended
fuels (called gasohol or using ethanol or meth-
anol)can attract moisture which leads to sepa-
ration and formation of acids during storage.
Acidic gas can damage the fuel system of an
engine while in storage. To avoid engine prob-
lems,thefuelsystem shouldbe emptiedbefore
storage for 30 days or longer. Drain the gas
tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel
next season. See STORAGE section foraddi-
tional information.
Choke/Fast
Idle Lever
OFF
FULL
S Press the throttle lock with your right hand.
Squeeze and hold the throttle trigger;
Press and hold the fast idle lock with your
forefinger; release the throttle trigger.
9
| Categories | Chainsaw Manuals, Poulan Pro Chainsaw Manuals |
|---|---|
| Tags | Poulan Pro 330 LE, Poulan Pro 380 LE |
| Model Year | 2002 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Chainsaw |
| Document File Type | |
| Publisher | poulanpro.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)