Repair instructions
7.4
Replacing a worn recoil spring
WARNING!
Make sure the recoil spring does
not fly out and cause injury.Wear
eye protection..
1
Remove the bolt from the centre of the pulley and
lift off the pulley and spring cassette.
2
Replace the defective spring cassette with a new
one.
3
Fit the bolt through the centre of the pulley and
tighten to a torque of 2–3 Nm. Tension the recoil
spring, see “Tensioning the recoil spring”.
7.5
Starter assembly – refitting
1
Position the starter assembly on the crankcase and
tighten the bolts to a torque of 2.5–3.5 Nm.
Fig 6
7.6
Ignition module – testing
If there is a fault in the ignition system the ignition
module must be tested before the ignition system
is removed.
Test the ignition module as follows:
•
Connect a test spark plug 502 71 13-01 to the
ignition lead and clip the test spark plug onto
the cylinder.
Fig 7
•
•
Turn the engine over using the starter cord.
If the test spark plug produces a spark the
ignition module is OK. (see figure 7)
English – 27
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 435, Husqvarna 435e, Husqvarna 440e |
| Model Year | 2003, 2004, 2005, 2006, 2007, 2008 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(3 votes, average: 5 out of 5)
Lawn and Garden readers have rated 2003-2008 Husqvarna 435 435e 440e Chainsaw Workshop Manual 5.0 out of 5.0 based on 3 product reviews. Excellent, just what was needed