Husqvarna 336 Chainsaw Owners Manual

MAINTENANCE
Starter device
Tensioning the recoil spring
!
Lift the starter cord up in
the notch on the starter
pulley and turn the starter
pulley 2 turns clockwise.
WARNING!
The recoil spring is in its tensioned position in its
cassette in the starter device. If the spring is handled
caralessly, it can pop out and cause personal injury..
Always be careful, when changing the recoil spring or
the starter cord. Always wear safety goggles for eye
protection.
NOTE! Check that the
starter pulley can be
turned at least half a turn,
when the starter cord is
entirely pulled out.
Changing a broken or worn starter cord
Loosen the screws, that
hold the starter device
against the crankcase and
remove the starter device.
Changing the broken recoil spring
Lift the starter pulley. (See,
Changing a broken or worn
starter cord).
Dismantle the recoil spring
cassette by lifting  it up out
of the starter device. Make
sure that the spring does
not pop out and cause
personal injury.
Pull out the cord approx. 30
cm and lift it up into the
notch in the pulley. Zero-set
the recoil spring by letting
the pulley rotate slowly
backwards. Undo the screw
in the centre of the pulley
and remove the pulley.
Lubricate the new recoil
spring with thin oil without
removing the spring out of
the cassette.
Fit the new spring cassette.
Insert and fasten a new
starter cord in the pulley.
Wind approx. 3 turns of the
starter cord on to the pulley.
Assemble the starter pulley
against the recoil spring, so
the end of the spring
Fit the cord pulley and
retension the recoil spring.
engages to the pulley. Fit
the screw in the centre of
the pulley. Carry the starter
cord through the hole in the
starter housing and the
starter handle. Make a knot
on the starter cord.
Starter device assembly
Assemble the starter
device, by pulling the starter
cord out first, then place the
starter against the
crankcase. Then slowly
release the starter cord so
that the pulley engages with
the pawls.
Assemble and tighten the
screws, which hold the
starter.
30
English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags
Model Year2003
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website