FUELING & LUBRICATION
STARTING
WARNING:
The chain must not
WARNING: Removefuel capslow-
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
ly when refueling.
FUELING ENGINE
BURETOR
ADJUSTMENT
within
this
This
engine
is
certified
to
operate on
operation,
manual. Avoid contact with the muffler. A hot
unleaded
gasoline.
Before
muffler can cause serious burns.
gasoline must be mixed with a good quality
2-cycle air-cooled engine oil
To stop the engine move the ON/STOP
switch to the STOP position.
synthetic
designed to be mixed at a ratio of 40:1.
Poulan/Weed Eater brand synthetic oil is
recommended.Mix gasolineandoilataratio
of40:1. A40:1ratiois obtainedby mixing3.2
ounces (95 ml) of oil with 1 gallon (4 liters) of
unleaded gasoline. Included withthis saw is
a 3.2 ounce container of oil. Pour the entire
contents of this container into 1 gallon of
gasoline to achieve the proper fuel mixture.
DO NOT USE automotiveoilor boat oil.These
oils will cause engine damage. When mixing
fuel, follow instructions printed on container.
Once oil is added to gasoline, shake container
To start the engine hold the saw firmly on
the ground as illustrated. Make sure the
chain is free to turn without contacting any
object.
Use only 15”---18” of rope per pull.
Hold saw firmly while pulling starter rope.
Starter rope handle
Left hand
on front
handle
momentarily
to assure that the fuel is
thoroughly mixed. Always read and follow the
safety rules relating to fuel before fueling your
unit.
Right foot through rear handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri-
cation. Lubrication is provided by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain. Too little oil will cause overheating
shownby smokecomingfromthechainand/
or discoloration of the bar.
IMPORTANTPOINTS TOREMEMBER
Whenpullingthestarterrope,donotusethefull
extentoftheropeas this can causethe ropeto
break. Do not let starter rope snap back. Hold
the handle and let the rope rewind slowly.
For cold weather starting, start the unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a
small amount (5 to 10%) of #1 Diesel Fuel or
NOTE: Do not cut material with the choke/
fast idle lever at the FULL CHOKE position.
STARTING A COLD ENGINE (or
warm engine after running out of
fuel)
NOTE: In the following steps, when the
choke/fast idle lever is pulled out to the full
extent, the correct throttle setting for starting
is set automatically.
kerosene.
Bar and chain oil must be free
flowing for the oil system to pump enough oil
for adequate lubrication.
Genuine Poulan or Poulan PROR bar and
chainoilis recommendedtoprotectyourunit
against excessive wear from heat and
friction. Poulanor Poulan PROR oilresists
high temperature thinning. If Poulan or
ON/STOP SWITCH
Poulan PROR
bar and chain oil is not
(SIDE VIEW)
available, use a good grade SAE 30 oil.
S Never usewasteoilfor bar andchainlubri-
ON
cation.
S Always stop the engine before removing
the oil cap.
STOP
IMPORTANT
1.
2.
Move ON/STOP switch to the ON posi-
tion.
Experience indicates that alcohol--blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads
to separation and formation of acids during
Pull out choke/fast idle to the full extent
(to the FULL CHOKE position).
Slowly press primer bulb 6 times.
Pull the starter rope sharply 5 times with
your right hand. Then, proceed to the
next step.
3.
4.
storage.
Acidic gas can damage the fuel
To
system of an engine while in storage.
avoid engine problems, the fuel system
should be emptied before storage for 30
days or longer. Drain the gas tank, start the
engine and let it run until the fuel lines and
carburetor are empty. Use fresh fuel next
NOTE: If the engine sounds as if it is trying
to start before the 5th pull, stop pulling and
immediately proceed to the next step.
season.
See STORAGE section for addi-
5.
Push the choke/fast idle lever in to the
HALF CHOKE position.
tional information.
9
| Categories | Chainsaw Manuals, Poulan Pro Chainsaw Manuals |
|---|---|
| Tags | Poulan Pro 220, Poulan Pro 260 |
| Model Year | 2004 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Chainsaw |
| Document File Type | |
| Publisher | poulanpro.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)