OPERATION
TO START ENGINE
SNOW THROWING TIPS
•
Be sure fuel shut-off valve is in the OPEN position.
•
•
•
•
Always operate the snow thrower with the engine at
full throttle. Full throttle offers the best performance.
Your snow thrower engine is equipped with a recoil
starter.
Go slower in deep, freezing or heavy wet snow.Use the
drive speed control, NOT the throttle, to adjust speed.
COLD START
It is easier and more efficient to remove snow imme-
diately after it falls.
1.
Insert safety ignition key into the ignition slot until it
clicks. DO NOT turn the key. Keep the extra safety
ignition key in a safe place.
The best time to remove snow is the early morning. At
this time the snow is usually dry and has not been ex-
posed to the direct sun and warming temperatures.
2.
3.
4.
Place throttle control in FAST position.
Rotate choke control to FULL position.
•
Slightly overlap each successive path to ensure all
snow will be removed.
Push the primer four (4) times if the temperature is
below 15°F, or two (2) times if temperature is between
•
•
Throw snow downwind whenever possible.
15°
and 50°F. If temperature is above 50°F, priming is
not necessary.
Adjust the skid plates to proper height for current snow
conditions. See “TO ADJUST SKID PLATES” in this
section of this manual.
NOTE: Over priming may cause flooding, preventing the
engine from starting. If you do flood the engine, wait a few
minutes before attempting to start and DO NOT push the
primer.
•
For extremely heavy snow, reduce the width of snow
removal by overlapping previous path and moving
slowly.
5.
Pull recoil starter handle quickly. Do not allow starter
rope to snap back.
•
•
•
Keep engine clean and clear of snow during use.This
will help air flow and extend engine life.
6.
When the engine starts, release the recoil starter
handle and slowly move the choke control to the OFF
position.
Aftersnow-throwingiscompleted,allowenginetorunfor
a few minutes to melt snow and ice off the engine.
Allow the engine to warm up for a few minutes. Engine will
not develop full power until it has reached normal operating
temperature.
Clean the entire snow thrower thoroughly after each
use and wipe dry so it is ready for next use.
WARNING:
Do not operate snow
WARM START
throwerifweatherconditionsimpairvis-
ibility. Throwing snow during a heavy,
windy snowstorm can blind you and be
hazardous to the safe operation of the
snow thrower.
Follow the steps above, keeping the choke in the OFF
position. DO NOT push the primer.
BEFORE STOPPING
Run the engine for a few minutes to help dry off any mois-
ture on the engine.
To avoid possible freeze-up of the starter, proceed as fol-
lows:
1.
Whiletheengineisrunning,pulltherecoilstarterhandle
with rapid, full arm strokes three or four times.
NOTE: The unusual sound made while pulling the recoil
starter handle will not harm the engine or starter.
IF RECOIL STARTER HAS FROZEN
If the recoil starter has frozen and will not turn the engine,
proceed as follows:
1.
Grasp the recoil starter handle and slowly pull as much
rope out of the starter as possible.
2.
Release the recoil starter handle and let it snap back
against the starter.
If the engine still fails to start, repeat the above steps.
13
| Categories | Poulan Pro Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Poulan Pro PP524B |
| Model Year | 2004 |
| Download File |
|
| Language | English |
| Product Brand | Poulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Snow Blower |
| Document File Type | |
| Publisher | poulanpro.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)