3.
Loosen the screw that secures the air filter cover to the
engine (Fig. 13).
Changing the Engine Oil
Change the oil after the first 5 operating hours and then
after every 50 hours or every season. Run the engine just
before changing the oil to warm the oil. Warm oil flows
better and carries more contaminants.
1
Note: Change the oil after every 25 hours when operating
under a heavy load or in high temperatures.
1.
Disconnect the wire from the spark plug (Fig. 7).
3
1003
2. Drain the gasoline from the fuel tank; refer to steps 3
2
and 4 of Emptying the Fuel Tank on page 18.
Figure 13
3.
4.
Remove the dipstick from oil fill tube and place a drain
pan next to the left side of the lawn mower.
1.
2.
Air filter
Screw
3.
Cover
Tip the lawn mower onto its left side, allowing the oil
to drain into the drain pan (Fig. 15).
4.
5.
Tilt the air filter cover down and clean it thoroughly.
Remove and discard the old paper air filter (Fig. 13).
Important
Do not try to clean a paper air filter.
6.
7.
8.
Insert a new air filter.
Install the air filter cover.
Connect the wire to the spark plug.
m-1782
1
Figure 15
1.
Oil fill tube
Servicing the Spark Plug
5.
6.
Turn the lawn mower upright.
Check the spark plug after every 25 operating hours. Use a
Champion RJ19LM spark plug or equivalent.
Fill the crankcase with fresh oil to the Full mark on the
dipstick. Refer to Filling the Crankcase with Oil on
page 8.
1.
2.
3.
Stop the engine and wait for all moving parts to stop.
Disconnect the wire from the spark plug (Fig. 7).
7.
Install the dipstick.
Clean around the spark plug and remove it from the
cylinder head.
8.
Wipe up any spilled oil.
9.
Connect the wire to the spark plug.
Recycle the used oil according to local codes.
Important
plug. Do not clean the electrodes because grit entering the
cylinder could damage the engine.
Replace a cracked, fouled, or dirty spark
10.
4.
Set the gap on the new plug to 0.030 in. (0.76 mm)
(Fig. 14).
Maintaining the Blade
A straight, sharp blade provides the best cutting
performance. Regularly inspect and sharpen the blade.
1
Warning
986
Figure 14
The blade is sharp; contacting the blade can result
in serious personal injury.
1.
0.030 in. (0.76 mm)
Wear gloves or wrap the sharp edges of the blade
with a rag.
5.
6.
7.
Install the spark plug and the gasket seal.
Torque the spark plug to 15 ft-lb (20 Nm).
Connect the wire to the spark plug.
1.
2.
Stop the engine and wait for all moving parts to stop.
Disconnect the wire from the spark plug (Fig. 7).
15
Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
---|---|
Tags | Toro 20036, Toro 20037 |
Model Year | 2004 |
Download File |
|
Document Type | Operator's Manual |
Language | EspanĚol |
Serial Number | toro_wbmdrsys.pdf | 88 | Lawn-Boy Walk Power Mower Drive Systems |
Product Name | Toro Super Recycler Mower |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Product Type | Walk Behind Mower |
Product Series | Toro 21" (53cm) 3 in 1 / Recycler |
Swath | 21 inch |
Discharge | Recycler |
Engine Manufacturer | Briggs & Stratton |
Engine Oil Type | 20 oz. (.6l) 30w or 10w-30 / API SH or higher |
Engine Motor Model # | 123K02-0114-E1 |
Engine Motor Size | 6.5 hp |
Engine Motor Type | 4 Cycle EPA1 |
Transmission Speed | Personal Pace |
Transmission Type | Gear |
Spark Plug | Champion RJ19LM |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5) Lawn and Garden readers have rated Toro 20036 20037 21-Inch Super Recycler Lawn Mower Operators Manual, 2004 5.0 out of 5.0 based on 1 product reviews.
This has been a great mower. Just looking for replacement parts from normal wear