McCulloch MC3516 Chainsaw Owners Manual

To stop  the engine  move the  ON/STOP
switch to the STOP position.
To start the engine hold the saw firmly on the
ground as illustrated. Make  sure the chain is
free to turn without contacting any object.
3.
4.
Pull choke/fast idle lever  out to the full
extent (to the FULL CHOKE position).
Pull the starter rope sharply 5 times with
your right  hand. Then,  proceed to the
next step.
NOTE: If the engine sounds as if it is trying
to start before the 5th pull, stop pulling and
immediately proceed to the next step.
Use only 15-- 18(40 -- 45 cm) of
rope per pull.
Hold saw firmly while pulling starter rope.
5.
Push the choke/fast idle lever in to the
HALF CHOKE position.
CHOKE/FAST IDLE LEVER
Starter Rope Handle
Left Hand
on Front
Handle
OFF
HALF
FULL
Right Foot Through Rear Handle
6.
7.
Pull the starter  rope sharply  with your
right hand until the engine starts.
Allow the engine to run for approximate-
ly 30 seconds.  Then, squeeze and re-
lease the throttle trigger to allow engine
to return to idle speed.
WARNING:  Donotattempttothrow
or drop--startthechainsaw.  Doingso willput
the operator at risk of serious  injury due to
loss of control of the chain saw.
IMPORTANT POINTS TO REMEMBER
Whenpullingthestarterrope,donotusethefull
extentoftheropeas   this can causethe ropeto
break. Do not let starter rope snap back. Hold
the handle and let the rope rewind slowly.
For cold  weather starting,  start the unit  at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
STARTING A WARM ENGINE
1.
Move ON/STOP switch to the ON posi-
tion.
2.
3.
Slowly press primer bulb 6 times.
To set the fast  idle, pull the choke/fast
idle lever out to the full extent (to the full
choke  position);  then  push the  lever
back in to the HALF CHOKE position.
Pull the starter  rope sharply  with your
right hand until the engine starts.
Squeeze and release throttle trigger  to
allow engine to return to idle speed.
NOTE:  Do not attempt to cut material with
thechoke/fastidlelever  intheFULLCHOKE
position.
4.
5.
HELPFUL TIP
If your engine still does not
start  after following  these
DIFFICULT STARTING (or starting a
flooded engine)
instructions,
please
call
The engine may be flooded with too much fuel
if it has not started after 10 pulls. Flooded en-
gines canbeclearedofexcess   fuelby pushing
the choke/fast idle lever in completely (to  the
OFF CHOKE position) and then following the
warm engine starting procedure listed above.
EnsuretheON/STOP  switchis intheONposi-
tion.  Starting could require pulling the starter
rope handle  many times  depending on how
badly the unit is flooded. If engine fails to start,
refer to the TROUBLESHOOTING TABLE or
call 1-800-554-6723.
1--800--554--6723.
STARTING A COLD ENGINE (orwarm
engine after running out of fuel)
NOTE:
In the  following steps, when  the
choke/fast idle lever is pulled out to  the full
extent, the correct throttle setting for starting
is set automatically.
IGNITION
SWITCH
CHAIN BRAKE
ON
STOP
WARNING:
If the  brake band is
worn too thin it  may break when the  chain
brakeistriggered.Withabrokenbrakeband,
the chain brake will not stop the chain. The
chainbrake shouldbe replacedby  anautho-
rizedservicedealer  ifany partis worntoless
than 0.020″  (0.5 mm)  thick. Repairs  on a
chain brake should  be made by  an autho-
rized service  dealer. Take your  unit to the
place of purchase if purchased from a ser-
vicing dealer,  or to the  nearest authorized
master service dealer.
Choke
Lever
1.
2.
Move ON/STOP switch to  the ON posi-
tion.
Slowly press primer bulb 6 times.
10
Product Specification
CategoriesChainsaw Manuals, McCulloch Chainsaw Manuals
Tags
Model Year2005, 2006, 2007, 2008, 2009, 2010
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
LanguageEnglish
Product BrandMcCulloch. Support Phone for US: Wheeled (Mowers, Tractors, Tillers, Snow Throwers) - 1-800-849-1297
McCulloch Handheld (Chainsaws, Trimmers, Blowers, Edgers) - 1-800-554-6723 All McCulloch Products - 1-800-521-8559, Chainsaw
Document File TypePDF
Publishermcculloch.com
Wikipedia's PageMcCulloch Motors
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website