Husqvarna 345e 346XP 353 TrioBrake Chainsaw Owners Manual

MAINTENANCE
Muffler
Starter
WARNING! When the recoil spring is wound
up in the starter housing it is under tension
and can, if handled carelessly, pop out and
cause personal injury.
!
Never use a machine that has a faulty muffler.
Care must be exercised when replacing the
return spring, starter cord or the drive disc
spring.Wear protective glasses and
protective gloves.
Changing a broken or worn starter cord
Regularly check that the muffler is securely attached to the
machine.
Loosen the screws that hold the starter against the
crankcase and remove the starter.
Some mufflers are equipped with a special spark arrestor
screen. If your machine has this type of muffler, you should
clean the screen at least once a week.This is best done with
a wire brush. A blocked screen will cause the engine to
overheat and may lead to serious damage.
Pull out the cord approx. 30 cm (12 inches) and hook it
into the notch in the rim of the pulley. Release the recoil
spring by letting the pulley rotate slowly backwards.
Note! The screen must be replaced if it is damaged. If the
screen is blocked the machine will overheat and this will
cause damage to the cylinder and piston. Never use a
machine with a muffler that is in poor condition. Never use a
muffler if the spark arrestor screen is missing or
defective.
345e:
Undo the bolt in the centre of the pulley and remove the
drive disc, drive disc spring and the pulley. Insert and
secure a new starter cord in the starter pulley. Wind
approx. 3 turns of the starter cord on the starter pulley. Fit
the starter pulley so that the end of the recoil spring hooks
into the starter pulley.Now assemble the drive disc spring,
drive disc and the bolt in the centre of the pulley.Carry the
starter cord through the hole in the starter housing and the
starter handle. Tie a good knot on the starter cord.
The muffler is designed to reduce the noise level and to direct
the exhaust gases away from the operator.The exhaust gases
are hot and can contain sparks, which may cause fire if
directed against dry and combustible material.
A muffler equipped with a catalytic converter significantly
reduces the amount of hydrocarbons (HC), nitrogen oxides
(NO) and aldehydes in the exhaust fumes. Carbon monoxide
(CO), which is poisonous and odorless, is not however
reduced! Consequently, never work in an enclosed or badly
ventilated area. Good air circulation should always prevail
when working in snowy hollows, ravines or in confined
conditions.
32
English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, , ,
Model Year2006, 2007, 2008, 2009, 2010, 2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 44 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website