Husqvarna 345e 346XP 353 TrioBrake Chainsaw Owners Manual

MAINTENANCE
346XP,
353:
Drive disc spring (B)
345e:
Undo the screw in the centre of the pulley and remove the
pulley. Insert and fasten a new starter cord to the pulley.
Wind approx. 3 turns of the starter cord onto the pulley.
Connect the pulley to the recoil spring so that the end of
the spring engages in the pulley.Fit the screw in the center
of the pulley. Insert the starter cord through the hole in the
starter housing and the starter handle. Make a secure
knot in the end of the starter cord.
Undo the bolt in the centre of the pulley and remove the
drive disc and the drive disc spring.
Replace the drive disc spring and fit the drive disc above
the spring.
A
A
B
3
45e
346XP, 353
Tensioning the recoil spring
Fitting the starter
Hook the starter cord in the notch in the pulley and turn the
starter pulley about 2 turns clockwise.
To fit the starter, first pull out the starter cord and place the
starter in position against the crankcase. Then slowly release
the starter cord so that the pulley engages with the pawls.
Note! Check that the pulley can be turned an additional 1/
2
turn when the starter cord is pulled all the way out.
Fit and tighten the screws that hold the starter.
Air filter
Replacement of broken recoil and drive
disc springs
The air filter must be regularly cleaned to remove dust and dirt
in order to avoid:
Carburettor malfunctions
Starting problems
Recoil spring (A)
Lift up the starter pulley. See instructions under the
heading Changing a broken or worn starter cord.
Remember that the recoil spring is coiled under tension in
the starter housing.
Loss of engine power
Unnecessary wear to engine parts
Excessive fuel consumption.
Remove the cassette with the recoil spring from the
starter.
Remove the air filter after taking off the air filter cover. When
refitting make sure that the air filter seals tightly against the
filter holder. Clean the filter by brushing or shaking it.
Lubricate the recoil spring with light oil. Fit the cassette
with recoil spring in the starter. Fit the starter pulley and
tension the recoil spring.
The filter can be cleaned more thoroughly by washing it in
water and detergent.
An air filter that has been in use for a long time cannot be cleaned
completely. The filter must therefore be replaced with a new one at
regular intervals. A damaged air filter must always be replaced.
A HUSQVARNA chain saw can be equipped with different
types of air filters according to working conditions, weather,
season, etc. Contact your dealer for advice.
English – 33
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, , ,
Model Year2006, 2007, 2008, 2009, 2010, 2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 44 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website