LUBRICATION
Bar Oil Fill Cap
INSPECT AND CLEAN UNIT AND
LABELS
S After each use, inspect complete unit
forloose or damaged parts. Clean the
unitandlabelsusing adamp clothwith
a mild detergent.
S Wipe off the unit and labels with a
clean dry cloth.
S Check bar and chain oil before use
and every 15 minutes while operating
the saw. See GUIDE BAR AND CHAIN
OIL under the OPERATION section.
SERVICE AND ADJUSTMENTS
CHAIN SHARPENING
4. Turn the adjusting screw counter-
clockwise to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the bar clamp.
Chain sharpening requires special tools.
You can purchase sharpening tools at an
authorized service dealer or go to a pro-
fessional chain sharpener.
5.
Carefully remove the new chainfrom
the package. Hold chain withcutters
facing as shown.
WARNING: Avoid accidental start-
ing. Always unplug saw from power
source before installing a bar and/or
chain.
CHAIN REPLACEMENT
Tip of
Bar
WARNING:
Wear
protective
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
Itisnormalforanewchaintostretchdur-
ing the first15 minutes of operation.You
should recheck your chain tension fre-
quently and adjust the chain tension as
required. See CHECK CHAIN TENSION
section.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Cutters
Depth Gauge
Replace the old chain when it becomes
worn or damaged. Use only the Low
Kickback replacement chain specified
in the listofavailable replacementparts.
Thechainmustcomplywithkickbackre-
quirementsofANSIB175.1 whentested
with this saw. See your authorized ser-
vice dealer to replace and sharpen indi-
vidual cutters on your chain.
Drive Links
6. Place chain aroundthe sprocketand
fit the drive links into the guide bar
groove and then into the teeth of the
sprocket in the tip of the guide bar.
TO REPLACE CHAIN:
1.
Disconnect the chain saw from the
power source.
Remove bar clamp nuts.
2.
3.
Remove bar clamp and old chain.
Bar Clamp
Nuts
7.
Hold the guide bar against the saw
frame and install the bar clamp. Be
sure adjusting pin is in the adjusting
pin hole in the bar.
Bar
Clamp
Adjusting Screw
13
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan ES350, Poulan ES350WT |
| Model Year | 2006 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)