engine and let it run until the fuel lines and
carburetor are empty. Use fresh fuel next
FUELING & LUBRICATION
season.
See STORAGE section for addi-
tional information.
FUELING ENGINE
STARTING
WARNING: Removefuel capslow-
ly when refueling.
WARNING:
The chain must not
HELPFUL TIP
Toobtain thecorrect oilmix
ratio, pour 3.2 ounces of
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
BURETOR
ADJUSTMENT
within
this
2--cycle
synthetic oil into
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
one gallon of fresh gas.
This
engine
is
certified
to
operate on
operation,
To stop the engine move the ON/STOP
switch to the STOP position.
To start the engine hold the saw firmly on the
ground as illustrated. Make sure the chain is
free to turn without contacting any object.
unleaded
gasoline.
Before
gasoline must be mixed with a good quality
2-cycle air-cooled engine oil
synthetic
designed to be mixed at a ratio of 40:1.
Poulan/WEED EATER brand synthetic oil is
recommended. A 40:1 ratio is obtained by
mixing3.2ounces (95ml) ofoilwith1gallon(4
liters) ofunleadedgasoline. Includedwiththis
saw is a 3.2 ounce container ofPoulan/WEED
EATER brand synthetic oil. Pour the entire
contents of this container into 1 gallon of
gasoline to achieve the proper fuel mixture.
Use only 15 --- 18 inches (38 --- 45 cm) of
rope per pull.
Hold saw firmly while pulling starter rope.
Starter rope handle
Left hand
on front
handle
DO NOT USE automotive or boatoil. These
oils willcauseenginedamage. Whenmixing
fuel follow the instructions printed on the
container. Always read and follow the safety
rules listed under HANDLE FUEL WITH
CAUTION.
Right foot through rear handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri-
cation. Lubrication is provided by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain. Too little oil will cause overheating
shownby smokecomingfromthechainand/
or discoloration of the bar.
IMPORTANTPOINTS TOREMEMBER
Whenpullingthestarterrope,donotusethefull
extentoftheropeas this can causethe ropeto
break. Do not let starter rope snap back. Hold
the handle and let the rope rewind slowly.
For cold weather starting, start the unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a
small amount (5 to 10%) of #1 Diesel Fuel or
NOTE: Do not cut material with the choke/
fast idle lever at the FULL CHOKE position.
kerosene.
Bar and chain oil must be free
HELPFUL TIP
If your engine still does not
start after following these
flowing for the oil system to pump enough oil
for adequate lubrication.
Genuine Poulan or Poulan PRO bar and
chainoilis recommendedtoprotectyourunit
against excessive wear from heat and
friction. Poulan or Poulan PRO oil resists
high temperature thinning. If Poulan or
instructions,
please call
1--800--554--6723.
STARTING A COLD ENGINE (or
warm engine after running out of
fuel):
Poulan PRO
bar and chain oil is not
available, use a good grade SAE 30 oil.
NOTE:
In the following steps, when the
S Never usewasteoilfor bar andchainlubri-
cation.
choke/fast idle lever is pulled out to the full
extent, the correct throttle setting for starting
is set automatically.
S Always stop the engine before removing
the oil cap.
IMPORTANT
ON/STOP SWITCH
(SIDE VIEW)
Experience indicates that alcohol--blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads
to separation and formation of acids during
ON
storage.
Acidic gas can damage the fuel
STOP
system of an engine while in storage.
To
avoid engine problems, the fuel system
should be emptied before storage for 30
days or longer. Drain the gas tank, start the
1.
Move ON/STOP switch to the ON posi-
tion.
9
| Categories | Chainsaw Manuals, Poulan Pro Chainsaw Manuals |
|---|---|
| Tags | Poulan Pro 220 LE, Poulan Pro 260 LE |
| Model Year | 2006 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Chainsaw |
| Document File Type | |
| Publisher | poulanpro.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)