Poulan Pro PP10530ES 421064 Snow Blower Owners Manual

OPERATION
TO START ENGINE
Be sure fuel shut-off valve is in the “OPEN” position.
6.   Whentheenginestarts,releasetherecoilstarterhandle
and slowly move the choke control to the “OFF” posi-
tion.
Your snow thrower engine is equipped with both a 120 Volt
A.C. electric starter and a recoil starter. The electric starter
is equipped with a three-wire power cord and plug  and is
designed to operate on 120 Volt A.C. household current.
Allow the engine to warm up for a few minutes. Engine will
not develop full power until it has reached normal operat-
ing temperature.
WARM START - RECOIL STARTER
Be  sure  your house  is  a  120  Volt A.C.  three-wire
grounded  system.   If  you  are  uncertain,  consult a
licensed electrician.
Follow the steps  above, keeping the choke  in the “OFF”
position.  DO NOT push the primer.
BEFORE STOPPING
Run the engine for a few minutes to help dry off any mois-
ture on the engine.
WARNING:  Do  not   use  the  electric
starter if your  house is not a 120  Volt
A.C.three-wiregroundedsystem.  Seri-
ous personal injury or damage to your
snow thrower could result.
IF RECOIL STARTER HAS FROZEN
If the recoil starter has frozen and will not turn the engine,
proceed as follows:
COLD START - ELECTRIC STARTER
1.
Grasp the recoil starter handle and slowly pull as much
rope out of the starter as possible.
1.
Insert safety ignition  key (packed separately in parts
bag)intoignitionslotuntilitclicks.    DONOTturnthekey.
Keep the extra safety ignition key in a safe place.
Place throttle control in “FAST” position.
Rotate choke control to “FULL” position.
Connect the power cord to the engine.
Plug the other end of the power cord into a three-hole
grounded 120 Volt A.C. receptacle.
Push the primer three (3) times.
2.   Release the recoil  starter handle and let it snap back
against the starter.
2.
3.
4.
5.
If the engine  still fails to start, repeat  the above steps or
use the electric starter.
SNOW THROWING TIPS
Always operate the  snow thrower with the  engine at
6.
7.
full throttle. Full throttle offers the best performance.
Push starter button until engine starts.
Goslowerindeep,freezingorheavywetsnow.Usethe
drive speed control, NOT the throttle, to adjust speed.
It is easier and more efficient to  remove snow imme-
diately after it falls.
The best time to remove snow is the early morning. At
this time the snow is usually dry and has not been ex-
posed to the direct sun and warming temperatures.
IMPORTANT: Do not crank engine more than five continu-
ous seconds between each time you try to start. Wait 5 to
10
8.
seconds between each attempt.
When the engine starts, release the starter button and
slowly move the choke control to the “OFF” position.
Disconnect the power  cord from the  receptacle first,
then from the engine.
9.
Slightly overlap  each  successive path  to ensure  all
snow will be removed.
Allow the engine to warm up for a few minutes. Engine will
not develop full power until it has reached normal operat-
ing temperature.
Throw snow downwind whenever possible.
Adjust the skid plates to proper height for current snow
conditions.  See “TO ADJUST SKID  PLATES” in this
section of this manual.
WARM START - ELECTRIC STARTER
Follow the steps above, keeping  the choke control in the
“OFF” position.
For extremely heavy snow, reduce the width  of snow
removal  by overlapping  previous  path  and  moving
slowly.
COLD START - RECOIL STARTER
1.
Insert safety ignition  key (packed separately in parts
bag)intoignitionslotuntilitclicks.    DONOTturnthekey.
Keep the extra safety ignition key in a safe place.
Place throttle control in “FAST” position.
Rotate choke control to “FULL” position.
Keep engine clean and clear of snow during use. This
will help air flow and extend engine life.
Aftersnow-throwingiscompleted,allowenginetorunfor
a few minutes to melt snow and ice off the engine.
Clean the entire  snow thrower thoroughly after each
use and wipe dry so it is ready for next use.
2.
3.
4.
Push the  primer four  (4) times if  the temperature  is
below 15°F, or two (2) times if temperature is between
15°
and 50°F. If temperature is above 50°F, priming is
WARNING:
Do  not   operate   snow
not necessary.
throwerifweatherconditionsimpairvis-
ibility.  Throwing snow during a heavy,
windy snowstormcan blind you and be
hazardous to the safe operation of the
snow thrower.
NOTE:  Over priming may cause flooding, preventing the
engine from starting. If you do flood the engine, wait a few
minutes before attempting to start and DO NOT push the
primer.
5.
Pull recoil starter handle quickly. Do  not allow starter
rope to snap back.
13
Product Specification
CategoriesPoulan Pro Snow Blower Manuals, Snow Blower Manuals
Tags
Model Year2008
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 40 pages
LanguageEnglish
Product BrandPoulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Snow Blower
Document File TypePDF
Publisherpoulanpro.com
Wikipedia's PagePoulan
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website