McCulloch M3816 M4218 Chainsaw Owners Manual

Oil Cap
IMPORTANT POINTS TO REMEMBER
Whenpullingthestarterrope,donotusethefull
extentoftheropeas   this can causethe ropeto
break. Do not let starter rope snap back. Hold
the handle and let the rope rewind slowly.
For cold weather starting, start the unit atfull
choke; allow the engine to warm up  before
squeezing the throttle trigger.
Fuel mix cap
FUELING ENGINE
NOTE:  Do not cut material with  the choke/
WARNING: Remove fuel cap slowly
when refueling.
fast idle lever at the FULL CHOKE position.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
NOTE:   In the  following steps,  when the
choke/fast idle lever is pulled out to  the full
extent, the correct throttle setting for starting
is set automatically.
This engine is certified to operate on unleaded
gasoline. Before operation,  gasoline must be
mixed with a  good quality 2-cycle  air-cooled
engine oil designed to  be mixed at a ratio of
40:1.
A 40:1 ratio is obtained by mixing 0,125
liter ofoilwith5liters  ofunleadedgasoline.   DO
NOT USE automotive or boat oil.  These oils
will cause engine damage.  When mixing fuel
follow the instructions printed on the container.
Always readandfollow thesafety  rulesrelating
to fuel before fueling your unit.
ON/STOP SWITCH
(SIDE VIEW)
ON
IMPORTANT
Experience indicates  that alcohol  blended
fuels  (called gasohol  or  using  ethanol or
methanol) can attract moisture which leads
to separation and formation of acids during
storage.Acidicgascandamagethefuelsys-
tem of an engine while in storage. To avoid
engine problems, empty the fuel system be-
fore storage for 30 days or longer. Drain the
gas tank, start the engine and let it run until
the fuel lines and carburetor are empty. Use
fresh fuel next season. Never use engine or
carburetor cleaner products in the fuel tank
or permanent damage may occur.
STOP
1.
Move ON/STOP switch to the ON posi-
tion.
2.
3.
Slowly press primer bulb 6 times.
Pull out choke/fast idle to the full extent
(to the FULL CHOKE position).
Pull the starter rope sharply 5 times with
your right  hand. Then,  proceed to  the
next step.
4.
NOTE: If the engine sounds as if it is trying
to start before the 5th pull, stop pulling and
immediately proceed to the next step.
CHAIN BRAKE
Ensure chain brake is  disengaged by pulling
thefronthandguardback   towardthefronthan-
dle as far as possible.  The chain brake must
be disengaged before cutting with the saw.
5.
Push the choke/fast idle  lever in to the
HALF CHOKE position.
CHOKE/FAST IDLE LEVER
(SIDE VIEW)
WARNING:
The  chain   must   not
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
BURETOR
ADJUSTMENT
within
this
Choke/
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
fast idle lever
OFF
HALF
FULL
6.
7.
Pull the  starter rope  sharply with  your
To stop  the engine, move  the ON/STOP
switch to the STOP position.
right hand until the engine starts.
Allow theenginetorunfor  approximately
To start the engine, hold the saw firmly on
the ground as illustrated below.  Make sure
the chain is  free to turn without  contacting
any object.
30
seconds. Then, squeeze and release
throttletriggerto  allow enginetoreturnto
idle speed.
STARTING A WARM ENGINE
1.
2.
3.
MoveON/STOP switchtotheONposition.
Slowly press the primer bulb 6 times.
Pull the choke/fast idle  lever out to the
HALF CHOKE position.
Use only 40 --- 45 cm of rope per pull.
Hold saw firmly while pulling starter rope.
4.
5.
Pull the  starter rope  sharply with  your
right hand until the engine starts.
Squeeze and release  throttle trigger to
allow engine to return to idle speed.
DIFFICULT STARTING (or starting a
flooded engine)
The engine may  be flooded with too much
fuel  if  it  has  not   started  after  10  pulls.
Flooded engines can be cleared  of excess
fuel by pushing  the choke/fast idle lever in
9
Product Specification
CategoriesChainsaw Manuals, McCulloch Chainsaw Manuals
Tags,
Model Year2009, 2010
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 17 pages
LanguageEnglish
Product BrandMcCulloch. Support Phone for US: Wheeled (Mowers, Tractors, Tillers, Snow Throwers) - 1-800-849-1297
McCulloch Handheld (Chainsaws, Trimmers, Blowers, Edgers) - 1-800-554-6723 All McCulloch Products - 1-800-521-8559, Chainsaw
Document File TypePDF
Publishermcculloch.com
Wikipedia's PageMcCulloch Motors
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website