Too Much Hook Angle
Squared Off
Corner
TO REPLACE CHAIN:
1. Disconnect the chain saw from the
power source.
2.
3.
Remove bar clamp nuts.
Remove bar clamp and old chain.
Wrong
WARNING: Maintain the proper
hook angle according to the manufac-
turer’s specifications for the chain you
are using. Improper hook angle will in-
crease the chance of kickback which
can result in serious injury.
Bar Clamp
Nuts
Bar
Clamp
Adjusting Screw
4.
Check and lower depth gauges.
Depth Gauge Tool
File
4. Turn the adjusting screw counter-
clockwise to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the bar clamp.
Depth Gauge
5.
Carefully remove the new chainfrom
the package. Hold chain withcutters
facing as shown.
S Place gauge tool on cutter.
S If the depth gauge is higher than
the depth gaugetool,fileitlevelto
the top of the depth gauge tool.
S Maintain rounded front corner of
depth gauge with a flat file.
NOTE: The very top of the depth
gauge should be flatwith thefront
half rounded off with a flat file.
Tip of
Bar
Ifyou require furtherassistance or are un-
sure about performing this procedure,
contact your authorized service dealer or
call our customer assistance help line at
1--800--554--6723.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
WARNING: Avoid accidental start-
ing. Always unplug saw from power
source before installing a bar and/or
chain.
Cutters
Depth Gauge
CHAIN REPLACEMENT
WARNING:
Wear
protective
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
Drive Links
6.
Place chain aroundthe sprocketand
fit the drive links into the guide bar
groove and then into the teeth of the
sprocket in the tip of the guide bar.
Itisnormalforanewchaintostretchdur-
ing the first15 minutes of operation.You
should recheck your chain tension fre-
quently and adjust the chain tension as
required. See CHECK CHAIN TENSION
section.
Replace the old chain when it becomes
worn or damaged. Use only the Low
Kickback replacement chain specified
in the listofavailable replacementparts.
Thechainmustcomplywithkickbackre-
quirementsofANSIB175.1 whentested
with this saw. See your authorized ser-
vice dealer to replace and sharpen indi-
vidual cutters on your chain.
7. Hold the guide bar against the saw
frame and install the bar clamp. Be
sure adjusting pin is in the adjusting
pin hole in the bar.
14
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan ES350, Poulan ES350WT |
| Model Year | 2010 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)