Training
eyes from foreign objects that may be thrown from the
machine.
•
Read, understand and follow all instructions on the
machine and in the manual(s) before operating this
machine. Be thoroughly familiar with the controls and
the proper use of the machine. Know how to stop the
machine and disengage the controls quickly.
Operation
•
Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
•
•
•
Never allow children to operate the machine. Never allow
adults to operate the machine without proper instruction.
• Exercise extreme caution when operating on or crossing
gravel drives, walks, or roads. Stay alert for hidden
hazards or traffic.
Keep the area of operation clear of all persons, particularly
small children.
Exercise caution to avoid slipping or falling, especially
when operating the machine in reverse.
• After striking a foreign object, stop the engine, remove
the ignition key, thoroughly inspect the machine for any
damage, and repair the damage before restarting and
operating the machine.
Preparation
•
If the machine should start to vibrate abnormally, stop the
engine and check immediately for the cause. Vibration is
generally a warning of trouble.
•
Thoroughly inspect the area where the machine is to be
used and remove all doormats, sleds, boards, wires, and
other foreign objects.
•
Stop the engine whenever you leave the operating
position, before unclogging the auger/impeller housing
or discharge chute, and when making any repairs,
adjustments or inspections.
•
•
Disengage all clutches and shift into neutral before
starting the engine.
Do not operate the machine without wearing adequate
winter garments. Avoid loose fitting clothing that can get
caught in moving parts. Wear footwear that will improve
footing on slippery surfaces.
•
•
When cleaning, repairing or inspecting the machine, stop
the engine and make certain the auger/impeller and all
moving parts have stopped. Disconnect the spark plug
wire and keep the wire away from the plug to prevent
someone from accidentally starting the engine.
•
Handle fuel with care; it is highly flammable.
–
–
–
Use an approved fuel container.
Never add fuel to a running engine or hot engine.
Do not run the engine indoors, except when starting
the engine and for transporting the machine in or out
of the building. Open the outside doors; exhaust fumes
are dangerous.
Fill fuel tank outdoors with extreme care. Never fill
fuel tank indoors.
–
–
Never fill containers inside a vehicle or on a truck or
trailer bed with a plastic liner. Always place containers
on the ground, away from your vehicle, before filling.
•
•
Exercise extreme caution when operating on slopes.
Never operate the machine without proper guards, and
other safety protective devices in place and working.
When practical, remove gas-powered machinery from
the truck or trailer and refuel it on the ground. If
this is not possible, then refuel such machinery on a
trailer with a portable container, rather than from a
gasoline dispenser nozzle.
• Never direct the discharge toward people or areas where
property damage can occur. Keep children and others
away.
–
Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times, until refueling
is complete. Do not use a nozzle lock-open device.
•
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
•
Never operate the machine at high transport speeds
on slippery surfaces. Look behind and use care when
operating in reverse.
–
–
Replace gasoline cap securely and wipe up spilled fuel.
If fuel is spilled on clothing, change clothing
immediately.
•
•
Disengage power to the auger/impeller when machine is
transported or not in use.
•
Use extension cords and receptacles as specified by
the manufacturer for all machines with electric starting
motors.
Use only attachments and accessories approved by the
manufacturer of the machine (such as wheel weights,
counterweights, or cabs).
•
•
Adjust the collector housing to clear gravel or crushed
rock surface.
•
Never operate the machine without good visibility or
light. Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
Never attempt to make any adjustments while the engine
is running (except when specifically recommended by
manufacturer).
•
Always wear safety glasses or eye shields during operation
or while performing an adjustment or repair to protect
• Never touch a hot engine or muffler.
3
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 37770, Toro Power Max 724 OE |
| Model Number | 37770 |
| Model Year | 2013 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English, Français |
| Serial Number | 313000001 - 313999999 |
| Product Name | Power Max 724 OE Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Snowthrower, Two Stage Power Max |
| Swath | 24 inch |
| Discharge | Two Stage |
| Engine Manufacturer | Briggs & Stratton |
| Engine Oil Type | 18 oz. (.54l) 30w or 10w-30 / API SF or higher |
| Gearbox Lubricant | 4.5 oz. (133ml) SAE 90 GL5 or higher |
| Engine Motor Model # | 12D1050172F8 |
| Engine Motor Size | 205cc |
| Engine Motor Type | 4 Cycle |
| Engine Speed | 3300±100 RPM |
| Transmission Speed | 6 Forward/2 Reverse |
| Transmission Type | Friction Disc |
| Tire Pressure | 17-20 PSI / 116-137 kPa |
| Spark Plug | Champion QC12YC |
| Spark Plug Gap | .030"/ .76mm |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)