Toro 37772 Power Max 826 OE Snowblower Manual, 2015

Adjusting the Discharge Chute  Storage
Latch
WARNING
If the discharge chute does not lock into the desired position
or does not unlock so that you can move it to another
position, adjust the discharge chute latch.
Gasoline vapors can explode.
Do not store gasoline more than 30 days.
1.
Loosen the clamp fastener on the chute support plate
until the cable is free.
Do not store the machine in an enclosure near
an open flame.
Allow the engine to cool before storing it.
Preparing the Machine  for
Storage
1
1.
On the last refueling of the year, add fuel stabilizer to
fresh fuel as directed by the engine manufacturer.
2
3
Note: Fuel should not be stored longer than suggested
by the fuel stabilizer manufacturer.
2.
Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
3.
4.
5.
Run the machine until the engine runs out of fuel.
Prime the engine and start it again.
g019021
Figure 49
Allow the engine to run until it stops. When you can
no longer start the engine, it is sufficiently dry.
1.
Cable conduit
Cable clamp
3.   Clamp fastener
6.
7.
8.
9.
Stop the engine and allow it to cool.
Remove the ignition key.
2.
2.
Remove any slack in the cable by pulling the cable
conduit rearward.
Clean the machine thoroughly.
Touch up chipped surfaces with paint available from an
Authorized Service Dealer. Sand affected areas before
painting, and use a rust preventative to prevent the
metal parts from rusting.
3.
Tighten the clamp fastener while holding the cable in
place.
Replacing the Drive Belts
10.
11.
Tighten all loose screws, bolts, and locknuts. Repair or
replace any damaged parts.
If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.
Cover the machine and store it in a clean, dry place out
of the reach of children.
Removing the Machine from
Storage
1.
Remove the spark plug and spin the engine rapidly
using the starter to blow the excess oil from the
cylinder.
2.
3.
4.
Install the spark plug and tighten it firmly.
Connect the spark plug wire.
Perform the annual maintenance procedures as given
in the Recommended Maintenance Schedule.
24
Product Specification
CategoriesSnow Blower Manuals, Toro Snow Blower
Tags,
Model Number37772
Model Year2015
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOperator's Manual
LanguageEnglish
Serial Number315000001 - 315999999
Product NamePower Max 826 OE Snowthrower
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower
Product TypeSnowthrower
Product SeriesSnowthrower, Two Stage Power Max
Swath26 inch
DischargeTwo Stage
Engine ManufacturerBriggs & Stratton
Engine Oil Type18 oz. (.54l) 30w or 10w-30 / API SF or higher
Gearbox Lubricant4.5 oz. (133ml) SAE 90 GL5 or higher
Engine Motor Model #12D1050172F8
Engine Motor Size205cc
Engine Motor Type4 Cycle
Engine Speed3300±100 RPM
Transmission Speed6 Forward/2 Reverse
Transmission TypeFriction Disc
Tire Pressure17-20 PSI / 116-137 kPa
Spark PlugChampion QC12YC
Spark Plug Gap.030"/ .76mm
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website