5.2
STORAGE
5.5 REMOVE ENGINE
When storing unit for extended periods of time, remove
all fuel from tank and carburetor (run dry). Refer to
Engine Manual.
1. Remove gas cap and top cowling.
2.
Remove fuel line at the engine and drain fuel into a
suitable container. Save for reuse or dispose of
properly.
5.3
CHECK FASTENERS
3.
4.
Remove drive belt from engine pulley.
Keep all nuts, bolts, and screws properly tightened.
Remove bolt and washer from engine shaft and
slide drive pulley halves from shaft.
5.4
CLEAN ENGINE COOLING SYSTEM
5.
6.
Disconnect throttle cable from engine.
Engine is air cooled. Air must circulate freely around
engine to prevent overheating.
On models with recoil starters, unbolt the bracket
that holds the recoil handle to the lower handle bar.
Every year (more often if conditions require) remove
cooling shrouds and clean cooling fins. Clean external
surfaces of engine of dust, dirt and oil deposits which
can contribute to improper cooling. Refer to Engine
Manual.
7.
Remove wiring for key switch.
8. Unscrew bolts from shaft side of engine.
9.
Unscrew mounting nuts on recoil side.
10.Disconnect choke cable.
11.Remove engine.
IMPORTANT: DO NOT operate engine with cooling
shrouds removed. Engine overheating and damage will
result.
Install in reverse order.
The engine on the Sno-Thro is a 2-cycle design. The
lubricating oil is mixed with the gasoline. Consult the
engine manufacturers manual for the proper grade and
mix ratio.
1
2
3
1.
2.
Hex Bolt
Drive Pulleys
3. Engine Mounting
Bracket
Figure 7
PS0034
5
- 14
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 938001, Ariens 938004, Ariens 938006, Ariens 938012, Ariens 938015, Ariens 938016, Ariens 938301, Ariens 938305 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)