SERVICE AND ADJUSTMENTS
3.
Remove auger drive pulley.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
4. Remove old belt.
Install (Figure 8)
SERVICE POSITION
1. Install new belt on drive pulley and idlers.
2.
3.
4.
Install drive belt on auger drive pulley.
Install auger drive pulley on unit.
Place unit on a flat level surface.
DRIVE BELT REPLACEMENT
Remove (Figure 8)
Connect extension spring to idler
arm/brake.
5.
6.
Adjust drive belt (see Drive Belt
Adjustment on page 16).
1.
2.
Remove cowl.
Disconnect extension spring on idler
arm/brake.
Install cowl.
1
2
1. Extension Spring
3
2.
3.
4.
5.
6.
Idler Arm/Brake
Idler
Drive Pulley
Drive Belt
Auger Drive
Pulley
4
5
6
Figure 8
OS4001
DISCHARGE CHUTE
ADJUSTMENT
If discharge chute rotates while throwing
snow, tighten four screws holding discharge
chute to housing to 11 – 12 lbf-in
2
(1.23
– 1.35 N•m).
1
3
IMPORTANT: DO NOT overtighten screws.
1.
Remove nut and bolt from rear of
discharge chute.
2.
3.
4.
5.
Tip discharge chute forward.
Tighten two rear screws.
Tighten two front screws.
4
Reposition discharge chute and fasten
with nut and bolt.
1. Rear Screw
2. Rear Nut and
Bolt
3. Discharge Chute
4. Front Screw
Figure 9
GB - 15
Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Ariens 938017, Ariens 938018, Ariens SS522EC, Ariens SS722EC |
Download File |
|
Document Type | Owner's Manual, Parts Catalog |
Language | English |
Product Brand | Ariens, Snow Blower |
Document File Type | |
Publisher | ariens.com |
Wikipedia's Page | Ariens |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)